1) biofilm formation performance
挂膜性能
1.
Modification of activated carbon and its biofilm formation performance on rotating biological contactor
活性炭改性及对生物转盘挂膜性能的影响
2) capability of adhesion
挂线性能
1.
Si-cutting fluid has some problems with the capability of adhesion to the cutting line,and cause too strong mechanical action during slicing,and effects the surface quality,cutting speed,saw life and yield of Si wafer.
Si片线切割过程中,切削液的挂线性能直接影响切片表面质量、切片速率、线锯寿命以及晶片成品率。
3) forming biofilm
挂膜
1.
Research on the improvement mechanism of PVC bio-carrier surface forming biofilm property by remote argon plasma;
远程氩等离子体提高PVC生物填料挂膜性能的机理研究
4) start-up
[英]['stɑ:t,ʌp] [美]['stɑrt,ʌp]
挂膜
1.
Study on effcet on BAC start-up of preoxidation by permanganate composite chemical;
高锰酸盐预氧化对生物活性炭挂膜过程的影响
2.
Experimental study on the start-up of trickling biofilter with ceramic sphere and the purification performance for toluene waste gas;
陶瓷球填料生物膜滴滤塔挂膜启动工艺及对甲苯废气的净化性能实验研究
3.
Experimental research on three start-up methods of aerobic filters;
好气滤池3种挂膜方法的实验研究
5) biofilm culturing
挂膜
1.
In this paper,the effects of different packing materials,different inoculation sludge on the biofilm culturing of effective microorganism (EM) biological contact oxidation reactor are studied.
在生物接触氧化反应器中投加有效微生物(EM)构成EM生物接触氧化反应器,研究了填料型式和污泥接种方式对EM生物接触氧化反应器挂膜效果的影响,考察了反应器启动阶段有机污染物的去除效果。
2.
With the wastewater from a brewery as an example, studied was the effect of different filling materials and different inoculation sludge on the biofilm culturing and starting process of the Effective Microorganism (EM).
以啤酒废水为例,讨论了不同填料、不同接种污泥对有效微生物群(EM)生物接触氧化反应器挂膜和启动过程的影响。
3.
The water temperature,air/water ration and influent ammonium loading rate(ALR) were the main factors for biofilm culturing and reactors startup.
生物膜法A/O/O脱氮系统处理城市污水中试挂膜启动研究结果表明:挂膜启动的关键在于进行硝化处理的二级生物接触氧化池能否培养出以硝化菌为优势菌种的成熟生物膜。
6) biofilm formation
挂膜
1.
Theexperiment shows that the pore gradient ceramics with the immobilization of biofilm has high porosity, largeratio surface area, excellent properties of biofilm formation, low losses of pressure, highly transmittingvelocity and media convey efficiency.
试验表明:这种固定化生物膜处理的孔梯度陶瓷,具有孔隙率高,比表面积大,挂膜性能好,压力损失小,较高传递速率和介质传质效率。
2.
The effects of hydraulic retention time,reactor structure, sludge inoculation concentration and carrier size on biofilm formation on carrier surface in an internal loop biofluidised bed were studied.
分别考察了水力停留时间、反应器结构、接种污泥量及载体粒径等因素对内循环三相生物流化床反应器载体挂膜的影响。
3.
The regularity of kinetics parameters was determined and biofilm surface was observed through microscopes during biofilm formation in nitrification filters by cinder and zeolite media.
研究了用煤渣和沸石作为填料的硝化滤器挂膜过程中动力学参数的变化规律,并对生物膜进行了电镜观察。
补充资料：线性吉布斯自由能关系
分子式：
CAS号：
性质：有机化合物同系物的一系列反应，由于取代基的改变或反应类型的改变，使反应的活化吉布斯自由能变△≠Gm与反应的标准吉布斯自由能变△rGm间具有线性关系即线性吉布斯自由能关系。从过渡态理论也可推得△≠Gm=x△rGm+[△≠Gm,0-x△rGm,0]，下角标“0”为参照反应物或参照反应的热力学函数。上式也可表示为lg(k/k0)=xlg(k/k0)，k及K为反应的速率常数和平衡常数。该关系提供了从少数化合物的性质来预计大量未知化合物的性能，求算未知反应的速率常数，以及推测过渡态构型。是一个十分有用的规律。
CAS号：
性质：有机化合物同系物的一系列反应，由于取代基的改变或反应类型的改变，使反应的活化吉布斯自由能变△≠Gm与反应的标准吉布斯自由能变△rGm间具有线性关系即线性吉布斯自由能关系。从过渡态理论也可推得△≠Gm=x△rGm+[△≠Gm,0-x△rGm,0]，下角标“0”为参照反应物或参照反应的热力学函数。上式也可表示为lg(k/k0)=xlg(k/k0)，k及K为反应的速率常数和平衡常数。该关系提供了从少数化合物的性质来预计大量未知化合物的性能，求算未知反应的速率常数，以及推测过渡态构型。是一个十分有用的规律。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条