1) thermochromic coatings
感温涂料
2) temperature-sensitive paint
温度敏感涂料
3) temperature controlling coatings
温控涂料
1.
Diffused reflection ratio of temperature controlling coatings is tested by double-ball method and is calculated basing on formula to give solar radiation absorbing co efficient a.
采用双球法测量温控涂料的漫反射比,公式计算得到涂料的太阳辐射吸收系数α,并且通过测量涂料表层涂膜温度的变化,从而得出太阳辐射吸收系数与涂料表层温度的相互关系。
4) temperature reduction paint
降温涂料
1.
In combination with the research on the application of temperature reduction paint in infrared camouflage,some methods for improving infrared temperature reduction camouflage paint are proposed in theory.
本文介绍了降温涂料的作用原理,并对大型军事目标的红外伪装方法作了阐述。
5) high temperature coating
高温涂料
1.
Through analyzing corrosion reason of steam injection line and requirements for outer corrosion-inhibiting coating of the line,WH-92 high temperature coating is developed.
分析了注汽管线的腐蚀原因及注汽管线对外防腐涂料的要求，研制了ＷＨ－９２型高温涂料，经现场应用。
6) insulating coating
保温涂料
1.
Based on the analysis of the heat transfer means of insulating coating,this paper has studied the effects of the density,the using temperature,the humidity,the internal structure,the main raw materials and the operating mode of insulating coating on the insulating properties,by test and application.
在分析保温涂料传热方式的基础上,通过实验和实际应用,分析研究了保温涂料的密度使用温度、所含湿度、主要原材料、内部结构形式、实际使用时的施工方法等对其保温性能的影响。
2.
The coagulation time of the general insulating coating bound with sodium silicate is very long,by selectin of coagulant,the coagulation time is largely shortened at normal temperature.
以水玻璃为主要粘结剂的普通保温涂料,其凝结硬化时间较长,选择合适的促凝剂加入后,极大地缩短了其在常温下的凝结硬化时间。
补充资料：燃速温度敏感系数
分子式：
CAS号：
性质：在燃烧压强恒定的条件下，推进剂线性燃速随便初始温度的变化率，可表示为：通常推进剂的值在0.002～0.008/K之间，当某推进剂的值为0.005/K时，则在233～333K温度范围，其线性燃速变化率可达50%。
CAS号：
性质：在燃烧压强恒定的条件下，推进剂线性燃速随便初始温度的变化率，可表示为：通常推进剂的值在0.002～0.008/K之间，当某推进剂的值为0.005/K时，则在233～333K温度范围，其线性燃速变化率可达50%。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条