1) Sol-gel transition temperature
凝胶相变温度
1.
The effect of PEG and PCL composition of thermosensitive PCL-PEG-PCL hydrogels on Sol-gel transition temperature and release rate of bovine serum albumin(BSA)were investigated.
共聚物的溶胶-凝胶相变温度由翻转试管法测定。
2) temporal temperature gradient gel electrophoresis
时相温度凝胶梯度电泳
3) gelation temperature
胶凝温度
1.
The aim of the present work is to investigate the characteristics including gelation temperature, sol-gel transition temperature (T_ s-g ), gel strength, stable viscosity, erosion and drug release behavior of the thermosensitive in situ gel which are composed o.
本文以泊罗沙姆Pluronic F127为温度敏感原位凝胶材料,考察了PluronicF127与Pluronic F68不同浓度处方对地塞米松磷酸钠温度敏感原位凝胶的胶凝温度、相转变温度、凝胶强度、稳态黏度、溶蚀和药物释放行为等特性的影响。
2.
The experimental results show that the gelation temperature at which G'= G", coincides with the gel point when the temperatu.
5-1℃/min,储能模量(G’)和耗能模量(C”)相等时的胶凝温度与按SY/T0541-94方法测定凝点基本一致,说明用小振幅振荡剪切温度扫描法来确定含蜡原油的凝点是可行的。
3.
The gelation extent and structure strength can be revealed by the viscoelastic parameters and gelation temperature measured by small amplitude oscillatory shear experiment.
结果表明,储能模量和耗能模量随测量温度的降低呈指数规律增加;存在使流变性恶化的“最差加热温度”;降温速率越高,测量温度下蜡晶结构强度和胶凝温度越低。
4) Gelation temperature
凝胶温度
6) gelation phase change
胶凝相变
补充资料：Sds-聚丙烯酰胺凝胶电泳凝胶电泳
sds-聚丙烯酰胺凝胶电泳（sds-page，sodium dodecyl sulfate-polyacrylamide gel electrohoresis）
在有去污剂十二烷基硫酸钠存在下的聚丙烯酰胺凝胶电泳。sds-page只是按照分子大小分离的，而不是根据分子所带的电荷和大小分离的。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条