1) SQ35 tobacco cutter
SQ35切丝机
1.
Failed in knife feeding in SQ35 tobacco cutter is a frequent failure caused by damaged primary and secondary worm gear pair resulted from over-wide clearance between tension roller and its shaft or serious wear of tension roller\'s sliding bearing.
SQ35切丝机在生产过程中经常出现刀辊不进刀故障,原因在于压链轮与轴的间隙过大,压链轮中的滑动轴承内圈孔径磨损严重,导致1、2级涡轮蜗杆出现胶合、滚压变形、折断等现象。
2) RC4 cutter
RC4切丝机
1.
The variation of cut width was caused by the linear velocity difference between the top and bottom bands in RC4 cutter.
通过计算和实验发现,RC4切丝机切丝宽度的计算公式中修正系数K取值过大,造成实际切丝宽度偏小,偏离设计值约8%。
3) slivering machine
切丝机
1.
Study on problems in the designing of movable corn stalk slivering machine;
移动式玉米秸秆切丝机设计中几个问题的研究
4) stem cutter
切梗丝机
1.
Fieldbus based on control system design of stem cutter;
基于现场总线的切梗丝机控制系统设计
5) tobacco cutting machine
切烟丝机
6) RC_4 cutter
RC-4切丝机
1.
Direct current speed regulation system and thyristor voltage regulation technology in SSD system were used in knife roller speed regulation system of RC_4 cutter, the buildup, structure and working principle were analyzed.
RC-4切丝机刀辊调速系统运用了直流调速系统和SSD系统中的晶闸管整流调压技术,对于SSD系统的组成、结构及工作原理进行了分析,较详细地说明了SSD直流调速系统常见故障的原因和处理方法,为维修该设备提供了参考。
补充资料：[3-(aminosulfonyl)-4-chloro-N-(2.3-dihydro-2-methyl-1H-indol-1-yl)benzamide]
分子式：C16H16ClN3O3S
分子量：365.5
CAS号：26807-65-8
性质：暂无
制备方法：暂无
用途：用于轻、中度原发性高血压。
分子量：365.5
CAS号：26807-65-8
性质：暂无
制备方法：暂无
用途：用于轻、中度原发性高血压。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条