说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> H∞保成本容错控制
1)  H∞ guaranteed cost fault tolerant control
H∞保成本容错控制
1.
By using the LMI method,the problem of H∞ guaranteed cost fault tolerant controller designs for T-S fuzzy system is studied.
应用线性矩阵不等式方法研究T-S模糊系统的H∞保成本容错控制器的设计问题。
2)  H∞ Guaranteed Cost control
H∞保成本控制
1.
The H∞ guaranteed cost control problem of the networked control system with a proportional-integral(PI) controller is studied.
研究了网络控制系统在比例积分输出反馈控制器下的H∞保成本控制问题。
3)  robust H∞ fault tolerant control
鲁棒H∞容错控制
1.
Because the demands of a floating bridge are so complex that the system can easily experience faults,an effectively robust H∞ fault tolerant control method for a floating bridge system was given via a region of linear matrix inequality(LMI) with consideration of dynamical boat failures.
由于浮桥系统的复杂性,考虑到动力舟在实际使用中容易发生故障,提出将系统在动力舟失效情况下的容错控制问题转换为LMI的可行性问题,设计浮桥的鲁棒H∞容错控制系统,以浮桥模型试验测得的水阻力等外界干扰力为依据,对浮桥动力固定特性进行数学仿真。
4)  guaranteed cost control
保成本控制
1.
Robust fault-tolerant guaranteed cost control for a class of uncertain discrete systems with state and control delays;
具有状态和控制滞后离散系统的容错保成本控制
2.
Robust guaranteed cost control based on LMI for the singular uncertain systems with time-delay;
基于LMI的奇异不确定时滞系统鲁棒保成本控制
5)  tolerant control
容错控制
1.
Study on LQR possessing integrality tolerant controller under condition of actuator fault;
执行器故障下的LQR完整性容错控制器设计
2.
Tilting mechanism failure inspection and tolerant control system;
摆式列车倾摆机构的故障检测和容错控制研究
3.
Intelligent Fault Diagnosis and Tolerant Control for Complex Nonlinear System;
复杂非线性系统的智能故障诊断与容错控制
6)  fault-tolerance control
容错控制
1.
Based on the reconstruct of mine hoist control system,aims at the high reliability of mine hoist sys- tem,is based on fault-tolerance control theory and method.
以煤矿矿井提升机电控系统的改造为背景,针对矿井提升机的高可靠性要求,基于容错控制理论和方法,提出了一种高可靠性的提升机电控系统。
2.
An fuzzy adaptive fault-tolerance control architecture was proposed for a class of continuous-time nonlinear dynamic systems.
针对一类不确定非线性系统提出了间接模糊自适应容错控制器的设计方法。
补充资料:[3-(aminosulfonyl)-4-chloro-N-(2.3-dihydro-2-methyl-1H-indol-1-yl)benzamide]
分子式:C16H16ClN3O3S
分子量:365.5
CAS号:26807-65-8

性质:暂无

制备方法:暂无

用途:用于轻、中度原发性高血压。

说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条