1) ladder mat and load cell apparatus
阶梯垫调整装置与测压仪装置
1.
This paper introduced the techniques improving of the finish mill,such as the introduction of finish mill guide settings and cooling water system,the adjustment of ladder mat and load cell apparatus,bends controlling of work rolls,hydraulic AGC controlling,as well as the technology improving to the tip cap transducer.
简要介绍对中厚板精轧机导卫装置与水冷系统、阶梯垫调整装置与测压仪装置、工作辊弯辊装置、液压AGC装置、顶帽传感器进行了技术改造。
2) upper step wedge
上阶梯垫装置
1.
Because of continuous changing of WR diameter and BUR diameter and intermittent changing of upper step wedge thickness and lower pass-line adjustment liner thickness, the article provides the key point how to choose such thickness following with roll diameter changing.
上阶梯垫装置和下轧制线调整装置是补偿工作辊和支撑辊直径磨损减小的装置。
3) adjusting device
调整装置
1.
Due to the unreasonable designed structure of the Φ550 rolling mill bottom roll adjusting device and its severe working environment, the phenomena of blocking and drive failure occur frequently.
Φ550轧钢机下调整装置由于原设计结构不合理,工作环境恶劣,经常出现卡死、传动失效等问题,对此进行了设计改进。
4) voltage adjustment device
电压调整装置
1.
Three-phase SCR voltage adjustment device has features of simple in structure,small in power wave form distrotion and small in high-order frequency magnetic wave interference,which is widely used in three-phase high power stove of cold state,thermal state,high resistance and great amplitude change.
三相可控硅电压调整器具有结构简单、电源波形畸变小和高次频磁波干扰小的特点,广泛应用冷态、热态电阻大,幅度变动大的三相大功率电炉中,介绍一种简易的三相可控硅电压调整装置的设计与调试方法。
5) oil pressure control unit
油压调整装置
6) constant voltage control device
恒压调整装置
补充资料：弯曲模的间隙调整装置
图1为弯曲模的间隙调整装置。在下模上开有长方形孔，其一端带有6°斜度。调整块安装在长方形孔内，相应的面也有6°斜度。调正杆头部是一个偏心圆柱体。调正杆旋转，偏心圆柱体带动调整块上、下滑动，由于有6°斜度，造成间隙变化，调整后用螺母锁紧调正杆。
图1 弯曲模的间接调整装置
1-下模 2-调整块 3-调整杆
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条