1) stiffener crack
筋条开裂
2) lacing wires crackles
拉筋开裂
1.
It is said that,since around the LP fourth stage blades nz-12～+15% binodal and trinodal curves had torsional oscillations,and the lacing wires and lacing poles were not clean before welding,with welding silver brazing were more and more there,which caused the lacing wires crackles,lacing wires silver brazing breaking down and other most blades tangential A0 static frequency unqualified.
对某发电厂1号汽轮机低压第4级叶片拉筋大面积银焊脱落,脱焊、拉筋开裂及绝大多数叶片组切向A0静频率不合格的原因作了分析,指出:低压第4级叶片本身存在nz附近-12～+15%有双节线、三节线扭振的共振因素,加之由于拉筋与拉筋孔清理不干净,反复施焊,问题愈积愈深,银焊愈堆愈多,致使问题的发生,文中提出了处理方案并实施。
3) cracking condition
开裂条件
1.
In order to study fracture property of RCC and cracking condition of induced joint,three point banding beam fracture tests of RCC have been carried out in this paper.
为了研究碾压混凝土的断裂特性和诱导缝的开裂条件,对多组碾压混凝土试件进行3点弯曲梁断裂试验,获得了碾压混凝土的抗拉、抗压强度,断裂韧度和断裂能,以及荷载-加载点挠度曲线、荷载-缝端开度曲线。
4) cases with end battens split
箱末端板条裂开
5) ribs
[英][rib] [美][rɪb]
筋条
1.
Analysis and numerical simulation on stability in irregular section of ribs bending process;
异型截面筋条压弯稳定性分析及数值模拟研究
2.
Integral wing-skin panel with grid-type ribs is a kind of light-weight structure, which applied in the aerospace field widely.
研究表明:网格式整体壁板增量成形过程中,塑性变形主要集中于筋条处,成形后的壁板主要是由于筋条发生塑性变形而导致壁板外形的改变。
6) rib
[英][rɪb] [美][rɪb]
筋条
1.
This paper describes the influence of vchations in dimensions, rib design and lug position of gridson the discharge performance of automotive batteries.
研究了板棚的外形尺寸、筋条结构及极耳位置对汽车用蓄电池放电性能的影响。
2.
To do grid design,it needs to consider comprehensively the application of battery,casting level,mould casting ability,and to analyze the structure and interval among the ribs.
板栅设计者要综合考虑蓄电池的用途、铸造水平、模具制造能力等,分析筋条结构及筋条间距的要求及影响。
补充资料：筋条
1.身体结实强健。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条