1) stirring speed
搅拌速率
1.
The effects of stirring speed and MgSO4 content on the calcium sulfate whisker growth process were studied by means of XRD and high resolution microscope.
以脱硫石膏为原料,采用水热法工艺制备硫酸钙晶须,并借助XRD、高分辨显微镜等分析方法,深入探讨了不同搅拌速率和不同硫酸镁加入量对硫酸钙晶须生长行为的影响。
2) stirring rate
搅拌速率
1.
The effects of emulsifier type and content,the process of adding monomer,the content of seed monomer,the adding rate of pre-emulsification monomer and the stirring rate on the stability of emulsion polymerization process were mainly investigated.
鉴于某种特殊功能涂料的应用,采用预乳化工艺和半连续种子乳液聚合技术,以过硫酸铵为引发剂,合成了羟基含量在48(左右的St-MMA-BA-AA-HEMA五元共聚苯丙乳液,重点考察了乳化剂的种类和用量、种子单体用量、单体滴加工艺、预乳化单体滴加速率和搅拌速率对乳液聚合工艺稳定性的影响。
2.
In the present work, morphological stability of globular crystal was experimentally studied using a succinonitrile-5%H_2O (molar fraction) transparent alloy under different undercoolings and stirring rates.
采用类金属丁二腈(SCN)和H_2O配制的SCN-5%H_2O(摩尔分数)透明合金研究了不同过冷度和搅拌速率下半固态球晶生长的形态稳定性。
3) critical stir speed
临界搅拌速率
1.
The results show that the micromixing can be enhanced via improving stir speed N and ultrasonic surging,and there exists a critical stir speed Nc at various ultrasonic powers.
结果表明:搅拌和超声波振荡对微观混合有明显的强化作用,在不同超声功率下,存在搅拌速率N对微观混合影响的临界搅拌速率Nc。
4) stirring rate
搅拌速度
1.
Effect of temperature and stirring rate on the diameter and the monodispersity of silica spheres
温度和搅拌速度对二氧化硅直径和单分散性的影响
2.
Moreover, the experiments of "the effect of the stirring rate,the temperature,and the effect of different pH on oil adsorption speed" were done to determine the best experiment conditions.
此外,还研究了搅拌速度、温度以及pH值对吸油性能的影响,发现:室温下吸油率最大、提高搅拌速度能够使吸油率提高;环境的pH值对吸油率的影响不大。
3.
This paper studies the relationship between the amount of particles in the composite coatings and the current density,stirring rate and the particle content in electrolyte solution.
采用正八棱柱体形状的阴极,在普通的瓦特型镀液中加入氧化铝颗粒制备复合镀层,研究了阴极电流密度、搅拌速度和颗粒在镀液中的浓度等因素对镀层内粒子含量与阴极不同方向之间的关系。
5) agitation speed
搅拌速度
1.
The major factor which affects freeze concentration is agitation speed.
影响冷冻浓缩的主要因素是搅拌速度。
2.
The results showed that the measures to strengthen heat and mass transfer between slurry and oxidant air are to enhance agitation speed,to arrange more air inputs that increase the quantity of air bubbles and decrease cubage,to properly enlarge the total area of air inputs so as to reduce air output .
通过对实验结果的分析,得出加强浆池中氧化空气与浆液之间的传热传质的措施有助于提高搅拌速度;布置更多的空气分布喷嘴,使得产生的气泡个数增加而体积减小;适当增加喷嘴的总面积,降低空气鼓出的速度。
3.
They are the choice of adsorbents, the additive amount of adsorbent, the bleaching temperature, the bleaching time and the agitation speed.
对茶籽油的脱色过程中,吸附剂、吸附剂用量、脱色温度、脱色时间和搅拌速度等因素影响茶籽油脱色效果的问题进行了研究,从中得出了茶籽油脱色的较佳条件。
6) agitation speed
搅拌转速
1.
The effects of agitation speed and substrate on γ-Poly(glutamic acid)(γ-PGA) Production of Bacillus subtilis NX-2 in 5 L fermenter were investigated.
采用Bacillus subtilisNX-2菌株,在5 L发酵罐批式操作过程中生物合成γ-聚谷氨酸,实验考察了搅拌转速(300~1 000 r/min)及底物质量浓度对生物合成γ-聚谷氨酸产率的影响。
补充资料：59600镁粉搅拌机操作规程
生产率：9箱/时，1箱=140公斤
1、遵守《铸造设备通用操作规程》有关规定。
2、工作前，先点动试车，然后空转2-3分钟，检查传动系统（电动机、联轴节、减速器）和叶轮的运动是否平稳，确认一切正常后，方可进行生产。
3、设备运转正常后，才能投料，注意不要夹入金属块或其它杂物。
4、工作后，清除槽内余料。
1、遵守《铸造设备通用操作规程》有关规定。
2、工作前，先点动试车，然后空转2-3分钟，检查传动系统（电动机、联轴节、减速器）和叶轮的运动是否平稳，确认一切正常后，方可进行生产。
3、设备运转正常后，才能投料，注意不要夹入金属块或其它杂物。
4、工作后，清除槽内余料。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条