1) combination of strengthening component
组合构件加固
5) composite member
组合构件
1.
Flexural behavior of composite members of T-section concrete-filled steel tubes
T形钢管混凝土组合构件抗弯性能
2.
To give the formula of cross-section capacity in eccentric compression,the theoretical model of composite member and judgment method of large or small eccentric compression have been brought forward.
目的确定组合构件的理论模型和大小偏心的判断方法,提出偏心受压正截面承载力公式。
3.
Through analysis and discussion of the structural form of composite members made by concreting by course during construction of the simple-supported bridges using the bridge support, some structural problems are noted for attention during design and construction.
通过对桥梁支架法施工的简支梁桥分层浇筑混凝土形成的组合构件结构形式的分析讨论,提出设计和施工中应注意的结构问题。
6) composite members
组合构件
1.
The experimental tests and numerical study of flexural bearing capacity of circular steel tube members filled with steel-reinforced high-strength concrete were carried out in the present paper to investigate the mechanical behaviors of composite members under the flexural loads.
通过钢骨-钢管高强混凝土组合构件抗弯试验,研究了这种组合构件在受弯时的特性,并对这种构件进行了数值分析,给出了钢骨-钢管高强混凝土构件抗弯承载力的计算公式,其公式计算结果与试验结果、数值计算结果吻合较好。
补充资料：Al-Li合金构件——歼7-II飞机舱口盖及副翼扰流片
Al-Li合金构件——歼7-II飞机舱口盖及副翼扰流片
Al—Ll合金构件——歼7一I 1机舱口盖及副翼扰流片 张自供稿
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条