2) sulfur-containing wastewater
含硫废水
1.
Study of the treatment of sulfur-containing wastewater in tanning industry;
制革工业含硫废水处理的研究
2.
The current status of carbide slag slurry wastewater treatment and the existing problems were analy-zed, it was indicated that, sulfur-containing wastewater might cause hidden trouble to the environment.
分析了电石渣浆废水治理方案的现状和问题,含硫废水有潜在环境风险。
3.
This article analyzes the source,composition and hazards of sulfur-containing wastewater from oil and gas fields and presents the chemical coagulation-ozonation composite technology from treating such water.
对油气田含硫废水来源、组成及危害进行分析,提出化学混凝-臭氧氧化复合处理的工艺技术。
3) Sulfur-bearing wastewater
含硫废水
1.
Treatment of sulfur-bearing wastewater and its investigation progression;
含硫废水的处理与研究进展
4) solid waste containing sulphur
含硫废渣
1.
Several technologies for sulphur recovery from solid waste containing sulphur generated during sulphuric acid production and sulphonation and liqiud waste containing sulphates generated in phosphoric acid manufacture are described.
介绍从硫酸和磺化剂装置产生的含硫废渣以及从磷酸装置产生的含硫酸盐废液中回收硫的几种技术硫过滤机的滤饼和熔硫沉降槽的梳渣与65%发烟硫酸或液体SO3一起送入反应器生成SO2,SO2作为产品或送入硫酸厂生产硫酸,惰性物料干燥后填埋处理。
6) mercury-bearing solid waste
含汞固废
1.
The optimum process parameters are obtained for the treatment of mercury-bearing solid waste:5 hours of calcinations at temperature 600 ℃,and in-furnace pressure about-600 Pa.
本文通过试验,阐明了含汞固废(危废)焙烧过程中汞的迁移情况,并得到了焙烧治理技术的最佳工艺参数为:焙烧温度600℃、焙烧时间5h、炉内压力-50Pa~-100Pa;焙烧后固废中残留汞含量小于0。
补充资料：焦化厂含酚氰废水处理设计(见含酚氰废水处理设计)
焦化厂含酚氰废水处理设计(见含酚氰废水处理设计)
design of phenolic and cyanic waste water treatment for coking plant
J iaohuaehang honfenging feishui ehuli sheji焦化厂含酚氛废水处理设计(design of phe-nolie and eyanie waste water treatment foreoking plant)见含酚氛度水处理设计。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条