1) One's attitude has softened.
态度软化。
2) dynamic softening
动态软化
1.
The results show that the considerable dynamic softening and ex.
研究结果表明:在500 ℃时,2519铝合金流动应力由于结构软化而存在相当强的动态软化和奇异的静态软化,导致第2道次的起始流动应力比前一道次的起始流动应力低;在热压缩变形道次间保温停歇后,流变应力出现明显的软化现象,保温停歇时间越长,合金软化率越高;变形及停歇保持温度越高,合金软化越严重。
2.
The compress during single and double passes for boron microalloyed steel was simulated using a gleeble-1500 thermal simulation testing apparatus, The quantitative effect of deformation temperature(T)、deformation degree(ε)、deformation rate(ε·)、primary grain size(d_0)、and interval time between passes(t)on static state and dynamic softening fraction(X)was obtained by nonlinear regression analysis.
运用gleeble-1500热模拟试验机November对含硼微合金钢进行了单、双道次压缩模拟,并通过非线性回归分析得到了静态与动态软化百分比(X)与变形温度(T)、变形程度(ε)、变形速率(ε·)、原始晶粒尺寸(d0)、道次间隔时间(t)之间的关系。
3.
It was indicated that the considerable dynamic softening and exceptional softening associate with a struc.
结果表明:在400℃时,1050和7075铝合金流动应力由于结构软化而存在相当强的动态软化和奇异的静态软化,导致第二道次的起始流动应力比前一道次的起始流动应力低;对于所有合金,静态软化随着变形温度和道次间保温及停留时间的增加而增加;但是在同一变形条件下,5182铝合金的静态软化速率比1050和7075铝合金高。
3) static softening
静态软化
1.
The static softening behavior of C-Si-Mn dual-phase steel as-hot-rolled using double-stage hot compression was studied on Gleeble 1500 tester.
采用后插法计算了在不同真应变条件下的静态再结晶率,通过双道次压缩测试静态软化动力学的实验表明,实验钢变形后很容易发生静态软化。
2.
The static softening behavior of hot deformation austenite of pipeline steel X60 and low-carbon bainitic steel JB700 were studied on MMS-100 thermal simulator,the effects of deformation temperature,strain magnitude and isothermal time on static softening rate were analyzed.
利用MMS-100热力模拟试验机研究了X60管线钢和JB700低碳贝氏体钢在不同变形温度、变形程度和变形后等温保持时间对奥氏体静态软化行为的影响。
3.
The dynamic and static softening behaviors of 2519 aluminum alloy in multi-stage hot compression were studied.
在Gleeble 1500热力模拟机上,采用双道次间隙式等温热压缩试验,对2519铝合金多道次热压缩变形过程中动态与静态软化特性进行了研究,变形温度为300 ~ 500 ℃,应变速率为0。
4) soft shape
形态软化
1.
In the development of ecological architecture,the soft shape tendency is emerging more and more clearly.
在生态建筑发展过程中,形态软化趋向日显突出。
5) softening temperature
软化温度
1.
The effect of high silicon low iron material on softening temperature,balling index,quality and output of sintering ore was investigated.
分析了高硅低铁物料对铅锌矿软化温度、成球性指数、烧结矿质量与产量的影响。
2.
The results show that the softening temperature of Cu-0.
4Cr的最佳软化温度约为773K,弥散的Cr可以有效地阻止合金的晶粒长大;在723K软化条件下,Cu-0。
3.
Their electrical conductivity, thermal conductivity and softening temperature were measured.
结果表明,纳米复合材料的电导率随AlN含量的增加而降低;纳米复合材料的热导率随AlN含量的增加而降低;纳米复合材料的软化温度随AlN含量的增加而提高,当AlN含量为0。
6) softening degree
软化度
1.
The adoption of enzyme solution, sequential freezing-thawing treatment, soaking in sugar solution at varying temperature, and the application of vacuum all proved to contribute to the improvement of the softening degree and the rate of sugar diffusion in production of preserved chestnut.
针对板栗果脯生产中存在的浸糖难、产品软化度不佳等关键性技术难题 ,采用一定浓度的淀粉酶处理、交叉冻融处理、冷热浸糖处理以及抽真空处理等措施 ,可明显提高浸糖率 ,显著改善果脯的软化
2.
It has been determined and measured the sample preparation of electrode paste softening degree testing condition and analysis method.
通过各种条件试验,确定了测定电极糊软化度的试样制备、试验条件及分析方法。
补充资料：髌骨软骨软化症
| 髌骨软骨软化症 chondromalaciapatellae 髌骨软骨面纤维化、碎裂又脱落等退行性变化引起的膝前疼痛症，上下台阶、长期屈膝或下蹲时疼痛加重。此病多从青年开始，女性多于男性，运动员更常见，与髌骨长期反复受到挤压摩擦有关。有的可发展为髌股骨关节病。髌骨轴位（切线位）X射线片及 CT可见关节面狭窄、硬化、髌骨倾斜及半脱位等变化。关节镜有助于早期诊断及手术。此病一般采用非手术疗法，改善膝部活动以减少髌骨软骨的压力及摩擦力 ，理疗及药物可缓解症状 ，有的可进行软骨面刨削、整修或软化病灶剔除、软骨下骨皮质钻孔术。重度髌骨软骨软化症病变范围广泛者可采用髌骨截骨术、髌骨成型术或髌骨切除术。 |
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条