1) saturation moments
饱和力矩
2) saturation magnetic moment
饱和磁矩
1.
In two-step heat treatment,the coervivity is reduced obviously and saturation magnetic moment is improved obviously with prolonging the heat-proof time.
用不同的热处理工艺对1J79合金进行退火,采用振荡样品磁强计(VSM)测得合金的磁滞回线,结果表明,二步法退火与一步法退火相比较,合金的矫顽力Hc显著降低;在二步法退火时,随着退火保温时间的延长,合金的矫顽力Hc显著降低,饱和磁矩增高。
2.
The dependence of cation distribution in lattice and saturation magnetic momenton the content of Co(Ⅱ)have been calculated.
考察了系列组成Ｃｏ＿ｚＦｅ＿３－ｘＯ＿４样品的穆斯堡尔效应，推算出晶体中阳离子分布与饱和磁矩同Ｃｏ（Ⅱ）含量的关系。
3.
Preliminary results show that the formation of nanocrystallites gives a drastic increase of the thermal expansion coefficient below Curie temperature TC and the saturation magnetic moment at 77 K, while the expansion coefficient above the TC remains almost unchanged as annealing temperature increase.
初步结果表明，纳米晶的形成导致Ｃｕｒｉｅ温度（ＴＣ）以下的热膨胀系数和７７Ｋ下的饱和磁矩急剧增加，而ＴＣ以上的热膨胀系数几乎不随退火温度变化，用因瓦效应解释了实验结果。
3) saturation impulse moment
饱和冲量矩
4) specific magnetic moment
比饱和磁矩
1.
Increase in the lattice parameters a and c, Curie temperature T_c, and specific magnetic moment σ_(?)(T=300K) were observed with iron substituting cobalt.
用水冷铜舟高频感应炉制备化合物R_2Co_(7-x)Fe_xB_3(R=Nd,Sm),当x=0～3时,该化合物可形成六角结构,随Fe含量的增加,晶格常数α、c增大,居里温度T_c和室温时的比饱和磁矩σ_2,也明显增加,样品在磁场中取向前后的X射线衍射谱分析表明,该化合物具有单轴各向异性,易磁化轴在C-轴上,利用CL-16直流磁特性测试装置,测量了该化合物粉末样品室温时的内禀矫顽力_MH_c。
5) saturation pressure
饱和压力
1.
Calculation procedure of saturation pressure of sandstone pool in Liaohe sag;
辽河坳陷砂岩油藏饱和压力计算方法研究
2.
Influence analysis of nanometer refrigerator oil on HFC134a saturation pressure
纳米冷冻机油对HFC134a饱和压力的影响研究
3.
PC foams were prepared by a foaming simulator at different processing conditions of foaming temperature,gas saturation pressure.
结果表明,对于微孔PC泡沫塑料的成型存在一个最佳温度值;随着饱和压力升高,泡孔直径变小,泡孔的密度增大;气体饱和时间对PC泡沫塑料泡孔结构的影响不是很明显,在一定的饱和时间范围内,延长PC发泡时间有利于得到更均匀的泡孔结构。
6) saturated stress
饱和应力
1.
The stress field,saturated stress,stress transfer efficiency and effective length in carbon nanotubes(CNTs) reinforced polymer composites were analyzed based on the three-phase concentric cylindrical shell model along with shear-lag arguments.
采用三相同轴柱壳剪切滞后模型,分析含有界面层的碳纳米管复合材料中的应力场、饱和应力和应力传递效率以及碳纳米管的有效长度。
补充资料：饱和
①在一定温度和压力下，溶液所含溶质的量达到最大限度，不能再溶解。②泛指事物在某个范围内达到最高限度：目前市场上洗衣机的销售已接近～。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条