1) flat air bearing
平式空气轴承
2) air-bearing
空气轴承
1.
The construction and principle of air-bearing type shapemeter are introduced.
简要说明了DAVY公司的vidimon辊空气轴承式板形仪的构成及基本原理,详细介绍了板形仪的常见故障及处理方法。
3) air bearing
空气轴承
1.
Using modified Reynomd s Equation, the method to solve dynamic rigidity and damping of the pressurized air bearing is given, and numerical calculation method has been adopted to analyze dynamic rigidity and damping of the bearing.
应用修正后的雷诺方程,介绍了一种求静压空气轴承的动刚度和阻尼的方法,并采用数值计算的方法分析了静压空气轴承的动刚度和阻尼。
2.
The pressure distributions on the surfaces of flat and two-trail sliders with different Knudson numbers and minimum gaps(flying height) between slider and disk were calculated,and the air bearing force was integrated consequently.
针对利用一般数值方法求解超薄气膜润滑雷诺方程时出现的不易收敛问题,提出了基于PDE工具求解气体润滑雷诺方程的方法,计算了具有不同克努森数和最小间隙的平板型滑块空气轴承和双轨型滑块的气膜压力分布。
4) Air Bearing
空气承轴
5) strip shape measuring roll based on pneumatic bearing
空气轴承式板形检测辊
1.
Static characteristic research on a strip shape measuring roll based on pneumatic bearing;
空气轴承式板形检测辊静态特性研究
2.
After introducing the operating principle and structure design of the strip shape measuring roll based on Pneumatic bearing,the design and calculating method of the orifice are analyzed.
介绍了空气轴承式板形检测辊的工作原理及结构设计。
3.
The research and design of the strip shape measuring roll based on pneumatic bearing;
本文在介绍空气轴承式板形检测辊的工作原理、结构设计的基础上,分析了节流孔的设计和计算方法。
6) air-bearing shapemeter
空气轴承式板形辊
1.
New calibration method of edge roll ring in air-bearing shapemeter
空气轴承式板形辊边部辊环标定新方法
补充资料：空气轴承
轴承的一种，利用包围在轴四周的压缩空气来支承轴，摩擦力小，转速很高。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条