1) coil wound rotor
线绕转子
3) wound rotor
绕线转子
1.
Quoted at the problem of bad contact between the brushes and slip rings of wound rotor motor of YZR range,this paper introduces a very efficient device for detecting the radian of the brush holder designed according to actual requirement.
针对 YZR系列绕线转子电机的薄弱环节—电刷与集电环接触不良的问题 ,本文介绍了一种根据实际需要而设计的非常有效的刷握弧度检测装
2.
Based on practice,the reasons of large and medium-sized high voltage wound rotor three-phase asynchronous motor rotor failure were expounded,and viable approach was designed.
结合生产实践,系统阐述了大中型高压绕线转子三相异步电动机转子产生故障的原因,并提出了可行的处理方法。
4) wound-rotor alternating current motor
绕线式转子绕组
5) winding of slipring rotor
绕线型转子绕组
6) wound rotor winding
线绕式转子绕组
补充资料:绕线转子感应电动机
绕线转子感应电动机
wound-rotor induction motor
比较,绕线转子结构较复杂,价格较贵,因此主要用在要求起动电流小,起动转矩大,或需要平清调速的场合。 绕线转子感应电动机的起动方法主要有:①转子串频敏变阻器起动(见交流电动机倾歌变阻器起动)。②转子串电阻起动(见交流电动机转子辛电阻起动)。为了在整个起动过程中尽量保持较大的起动转矩,可以在电动机转起来以后.采用逐级切除起动电阻的分级起动。其优点除上述外,还因转子只申电阻没有电抗,起动过程中功率因数比申频敏变阻器起动时要高,且起动电阻可同时兼作调速电阻。 为了防止电动机在运转时电刷磨损和减少摩擦损耗,有的电动机装有电刷提起装置。当电动机起动完毕时,利用这种装置,把转子绕组彼此短路,然后将电刷从滑环上提起。 绕线转子感应电动机的主要调速方法有:①交流调压调速;②转子串电阻交流调速;③交流串级调速.raox一an zhuonzl gany.ngd旧ndongJI绕线转子感应电动机(wound一rotor inductionmotor;slip一ring induetion motor)定子上的一次绕组连接于电源,转子上具有与集电环连接的多相绕组的感应电动机。图为三相绕线转子感应电动机绕线转子感应电动机示意图示意图.转子三相对称绕组可以连成Y形接线或△形接线.这种转子的特点是转子绕组可以外接电阻,以改善电动机的起动性能或用以调节转速。与笼型转子
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条