1) medium sweep elbow
中等弯曲半径弯头
2) bending radius
弯曲半径
1.
The design of the Decorative Stainless-Steel Elbow, the calculation of the thinnest thickness of the elbow wall, and the calculation of the smallest relative bending radius of the elbow, the forming die for the elbow and the attention items in the design of the die were introduced.
介绍了不锈钢装饰弯头的设计、弯头最小壁厚的计算、弯头最小相对弯曲半径的计算 ,并介绍了弯头成形模以及模具设计中应注意的问题。
2.
The strained lattice parameters, misorientation, bending radius and stress of ZnO films were estimated.
高温直接生长的样品弯曲半径小而应力更大;实验测量的应力值和理论计算的热应力值之间存在差异,原因主要是晶格失配应力的存在。
3) bend radius
弯曲半径
1.
Experiments of single mode fiber bend loss with the change of bend radius from 1 to 9 mm are made at 90° and 180°respectively.
系统对单模光纤弯曲损耗随弯曲半径(1~9 mm)进行90°和180°的弯曲实验,结果显示,光纤弯曲损耗随弯曲半径的增加呈下降趋势,光纤弯曲对不同波长的光损耗不同,且出现弯曲损耗的振荡,并进行了数值仿真和实验数据的比较。
2.
Based on field data of the river bend in middle and lower Hanjiang River and in Jingjiang River,the relation between the variation of bend radius of flow dynamic axis and bend bypassing and shoal cutting is expounded.
在分析汉江中下游以及荆江河湾实测资料的基础上,阐述了河湾水流动力轴线弯曲半径变化与切滩撇弯之间的关系,大量相关实测资料说明当河湾的来水条件和河湾形态发生变化时,会造成河势与水流动力轴线走向发生变化,从而引起切滩撇弯的发生。
4) curve radius
弯曲半径
1.
Through analyzing and arranging the actual data measured of mountain area rivers in southwest of China,we summarize:The ideal channel flow route should have sine derivative curve flow route,harmonized flow direction,good flow route corner and bigger curve radius.
通过对西南地区山区河流实测资料进行分析整理 ,总结出 :正弦派生曲线水流线路、协调的水流方向、良好的水流转向角及较大的弯曲半径为理想的航道水流流路 ,并提出了该规律在工程设计中的应
5) iso-diameter elbow
等径弯头
6) long turn elbow
大弯曲半径弯管
补充资料：中等
1.介于上等与下等或高等与初等之间的等级。 2.形容(身材)不高不矮。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条