1) apron control centre
停机坪控制中心
2) parking apron
停机坪
1.
The equipment has been put in use at the capital airport,and has also been the best choice to clean the parking apron.
设备在首都机场使用,已成为机场停机坪清洁维护首选装备。
2.
, for the construction of cement concrete parking apron.
详细介绍了在水泥混凝土停机坪施工中采用的机械摊铺、振捣、揉浆、真空吸水、刻槽、切缝等施工技术措施，为建筑工程中大面积楼、地面的施工提供了有益的借鉴。
3.
The paper introduces the objectives,contents,methods and principles of laying out measuring points of the third-party monitoring for shield driving under Capital Airport Line T2 including sliding area and P4 parking apron.
介绍首都机场线T2支线采用盾构法施工下穿机场滑行区和P4停机坪的情况,阐述第三方监测的目的、内容、方法及测点布设原则,对监测成果进行分析。
3) parking lights
停机坪灯
4) central control computer
中心控制计算机
1.
The signal simulator for radar presented in this paper is mainly used to simulate and generate multiple-beam-position signal and response the timing control of the central control computer simultaneously.
介绍某雷达信号模拟器主要是为了完成多波位信号的模拟产生,同时响应中心控制计算机的定时控制。
5) motor control center
电动机控制中心
1.
As core of the front end unit of motor control center,the characteristics of single-chip microcomputer 80C196,the protective principle of the protection and measurement & control unit,the hardware configuration and software principle of the unit were presented.
介绍了作为电动机控制中心(MCC)前端设备的核心80C196单片机的特点,保护测控单元的保护原理和装置硬件构成及装置软件原理。
2.
In this paper, an open monitoring and control software in motor control center was introduced.
介绍了具有开放性的电动机控制中心监控软件。
6) motor control center(MCC)
电机控制中心
补充资料：停机坪
见飞机场飞行区。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条