说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 交通灯号转换系统
1)  signal relay system
交通灯号转换系统
2)  traffic signal lamp system
交通信号灯系统
1.
Dynamic control of traffic signal lamp system;
交通信号灯系统的动态控制
3)  the traffic signal lamp control system
交通信号灯控制系统
4)  traffic light control system
交通灯控制系统
1.
Design of Traffic Light Control System Base on FPGA/CPLD and VHDL;
基于FPGA/CPLD和VHDL语言的交通灯控制系统设计
2.
The traffic light control system usually must realize the automatic control and the hand control.
交通灯控制系统通常要实现自动控制和手动控制其红绿灯的变化,基于FPGA设计的交通灯控制系统电路简单、可靠性好。
3.
In view of the problems concerning the installation and reconstruction of a traffic light control system in a city,this paper presents a wireless control system based on the combination of the ZigBee and solar energy technology,and elaborates on the network structure and the hardware and software design of a main crossroad controller along with an analysis of the corresponding key technique.
针对目前城市道路交通灯控制系统的安装、改造的问题,提出了采用ZigBee和太阳能结合的无线控制系统。
5)  control system for traffic light
智能交通灯系统
6)  signal translating system
信号转换系统
补充资料:道路交通信号灯
      用于给互相冲突的交通流分配有效的通行权,以提高道路交通安全和道路容量的一类交通灯。它分为:给出一种方向性信号、显示单一颜色的交通控制信号灯如红绿灯,和表示特定内容如行人的走和停(用箭头表示)、车辆的前进方向等带有符号的信号灯两类。
  
  信号灯除应满足交通灯的一般要求外,还应满足下列要求:①发光面具有一定的直径,分为200mm与300mm两种,表面亮度应尽可能均匀。②颜色有红、黄、绿3种光色,有时也用白色。③用帽沿等措施以减少阳光斜射在灯具出光面上时产生的假显示现象。
  
  对发出单一颜色的交通信号灯,要求:①光强:在背景亮度104cd/m2、视距100m时,红光为200cd,推荐的红黄绿三色光强之比为1:1.3:5。除城市高速道路和有明亮背景的城市外,晚上的光强可低些,因此可采用200cd与50cd两种光强。②光强分布:光分布左右对称,在光强降到峰值光强的50%处的光线,应处在光轴左右各10°和下方5°~7°的位置上。
  
  符号信号灯的图案是将人、自行车、箭头等用剪影的方法置于圆形灯口面上,剪影部分发光,周围不发光。图案的设计必须减少因瞳孔较大或不正常折射误差(如近视产生的"散光"现象 ── 一种类似在雨、雾中产生因光晕而减低符号可辨认程度的现象)。例如箭头符号"←"中的"<"与"-"应分开为"<-"。
  
  安装在路面上方的信号灯的高度为4.5~5.7m,装在路边的为2.4~4.5m。人行信号灯的高度为2.1~3.0m。
  

说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条