1) overfiren air port
二次风口
2) secondary air inlet
二次进风口
1.
The effects of the area ratio of secondary air inlet area to suction nozzle,height of secondary air inlet and wind speed on the single piping type suction nozzle in the pneumatic conveying was studied.
研究了二次进风口面积比、二次进风口高度和输送风速等因素对单筒型吸嘴的性能影响。
3) secondary tuyere
二次风口，二次风嘴
4) overfire air port
二次风喷口(炉排炉的)
5) tertiary air orifice
三次风口
1.
Working condition and orifice type of vertical cyclone-type boiler tertiary air orifice are analyzed.
分析了立式旋风炉的三次风口的烧损现象、工作条件、风口型式 ,经过对不同材料、不同形状的风口的讨论及实践 ,得出结论 :把非金属耐热烧结预件和密封钢板相结合 ,可保证三次风口长周期无损运
6) secondary air distribution mode
二次风配风
1.
Sensitivity analysis of effect of the secondary air distribution mode on the unburned carbon is studied in this paper,meanwhile,a multi-complex algorithm is employed to perform a search to determine the optimum solution of optimal recursive neural network(ORNN),which is used to set up a boiler property model,so as to obtain currently optimum distribution mode of secondary air.
利用优化递归的BP神经网络进行锅炉飞灰含碳量建模,并对锅炉二次风配风方式的影响进行敏感性分析,同时采用群体复合形法对运行工况寻优,获得各种工况下二次风开度的优化调整方式。
补充资料：进次
1.犹进驻。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条