Effect of Si on the microstructure and thermal conductivity of pressureless infiltrated SiC_p/Al composites;

Effect of preparation condition on the thermal conductivity of xonotlite-silica aerogel nanoporous super insulation materials;

Influence of substrate thermal conductivity on the phase composition of high velocity oxy-fuel sprayed Al-Cu-Cr quasicrystalline coatings;

Research on high precision fast detection system for sea sediment heat conductivity;

The effect of pressure in the experiment measuring heat conductivity of air;

An application of the theory of thermal wave: dynamic measure of the heat conductivity of a good thermal conductor;

The measurement and evaluation of thermal conductivities of nanofluids;

Measurement of the thermal conductivities of CH_3COONa·3H_2O, CH_3COOLi·2H_2O,and Na_2S_2O_3·5H_2Oin the temperature range from 10℃ to 80℃;

Measurement of thermal conductivities of Muraenesox cinereus at different temperatures;

Thermal barrier coating-thermal conductivity measurement and methods to rreduce the thermal conductivity*;

Liquid thermal conductivity equation based on the square-well model;

The determination of thermal conductivity of solution in NaCl and H_2SO_4;

In this paper, the effect of hollow cathode discharge was applied to the sintering of A1N ceramic, AlN ceramics with high performances of high density and excellent conductivity were obtained with A1N powder as the raw material which was produced by the method of SHS and Y2O3-CaO-Li2O as the additive.

In the second part, we have mainly introduced a method for measuring the principal conductivity and axial orientation of thermal.

The results show that the content of A1N increases with the ratio of Al to BN increasing, and the density, hardness, bending strength, thermal conductivity and dielectric constant also increase with the ratio of Al to BN increasing.