1) amount of dispersion
离差量;偏差量
2) Weight Deviation
重量偏差
1.
To guarantee the mechanical performance of HRB 335 hot rolling ribbed reinforcing bar, its production process, composition property and weight deviation are analyzed and researched, some suggestions proposed.
为确保HRB335热轧带肋钢筋力学性能,对其生产工艺、成分性能、重量偏差进行了分析研究,提出合理制定钢筋内控化学成分及重量偏差的建议并指导生产,取得了满意效果。
2.
The method to decide the inside diameter of the hot rolled ribbed steel bars on the basis of weight deviation is proposed.
通过对ＧＢ１４９９—９１中几何指标的分析，提出了以重量偏差为基准确定热轧带肋钢筋内径的方法。
3.
Combining yarn weight deviation and drawing frame weight deviation to adjust wheel gear,valid control weight deviation per hundred meter yarn and weight CV% was achieved.
兼顾成纱重量偏差和末并单机台重量偏差来调整末并牵伸齿轮,达到有效控制成纱百米重量偏差和重量CV%的目的。
3) bias vector
偏差矢量
1.
Research on the well trajectory bias vector control method of the rotary closed-loop drilling technology;
闭环钻井井眼轨迹偏差矢量的控制方法
4) basis weight difference
定量偏差
1.
The properties of the sheet formed on this vat was determined,the results showed that this vat had better stock distributing and sheet forming properties and the sheet had less basis weight difference incross direction,the paper strength in MD was similar to that in CD.
介绍了孔板布浆导流短孤形板网槽的结构，并对其成形纸页性能进行测定，结果表明，这种网槽有较好的布浆成形性能，纸页横幅定量偏差较小，纵横向强度比较接近。
5) flow rate deviation
流量偏差
1.
The intrinsic flow rate deviation in the water-wall of boiler and its overtemperature tube-burst conditions have been briefly analysed.
简要分析了锅炉水冷壁固有流量偏差及其超温爆管的条件。
6) air quantity difference
风量偏差
1.
Through analog computation of four conditions of the secondary air duct,the reasons of air quantity difference between the front wall and the rear wall are found out.
通过对二次风道的4个工况的模拟计算,找出前后墙风量偏差的原因,提出结构优化的方法,使前后墙风量合理分配,稳定了锅炉的燃烧工况。
补充资料：离差
分子式：
CAS号：
性质：见偏差
CAS号：
性质：见偏差
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条