1) corrected coefficient of determination
校正的测定系数
2) quantitative calibration factor
定量校正系数
1.
They are, the preparation of S 2OF 10 by preparative chromatography with adsorption/thermal desorption, the standard sample of S 2OF 10 gas prepared by exponential dilution and the gas chromatography/flame photometric detector(GC/FPD) determination of trace S 2OF 10 from an SF\-6 sample with quantitative calibration factor.
提出了一系列的安全、方便、可靠、在线和可连续操作的热解吸/色谱分析柱制备 S2 O F10纯品、指数稀释法配制 S2 O F10标准样品、应用定量校正系数测定样品中痕量 S2 O F10的方法和技术。
3) correction factor
校正系数
1.
The correction factor (the ratio of true value to observed value) is 1.
6mg/mL之间,其校正系数(异丙醇的实际值与测定值之比)为1。
2.
Discussed the inaccurate analysis of content of the benzene in the gas caused by inacurate sampling connection, correction factor, exhales and and alysis time and gives the improvement measures.
从采样针筒接口、校正系数、放散和分析时间等方面探讨了煤气含苯分析不准确的原因及改进措施 ,从而提高了煤气含苯分析的准确度。
3.
Also the correction factor of groups was educed; the correlation coefficient of "one year old"Merino s day age and body weight, cashmere yield and wool length w.
337(呈中度正相关)和回归方程,将羔羊日龄按顺序5 d一组取组限中数代入回归方程,得断乳体重理论值,并导出各组的校正系数;同时,计算周岁羊日龄与体重、产毛量及毛长度的相关系数,并进行了初步分析。
4) proofread coefficient
系数校正
5) correction coefficient
校正系数
1.
Study on the determination and the correction coefficient of activity of lysozyme in infant milk formula;
婴儿配方粉中溶菌酶活力的测定及其校正系数的研究
2.
The correction coefficient needs to be adopted to calculate the determinated value of work curve,it simplifies the operation,reduces error and enhances the accuracy and precision.
采用大肚移液管 ,将标准溶液配制成整数级别的贮备液、中间液、使用液时 ,利用工作曲线计算测定值需要引入校正系数 ,利用该方法可简化操作 ,减少误差提高实验准确度、精密度。
3.
In the paper,the method on error-measuring in Controlling TSP using blank whole-process filtering film technique was introduced,Correcting the TSP measuring values of the low concentration and high Concentration by adopting the correction coefficient respectively.
即用其校正系数分别对低浓度和高浓度TSP测值进行校正,取得较好的效果。
6) correct coefficient
校正系数
1.
Extrapolating model of correct coefficient in the dropvolume method for determination of surface or interfacial tension;
测定表面张力的滴体积法校正系数的外推模型
2.
The curve fitting of correct coefficient in the drop volume method for determination of surface tension was carried out by means of Powell method and multivariate regression.
应用无约束优化的Powell方法和多元回归方法 ,对滴体积法测定表面张力计算公式中的校正系数进行曲线拟合。
3.
Selecting 2000 seismic data(h≤80km) from Mudanjiang Seismic stations records and the magnitude of《Preliminary Seismological Report of Chinese Seismic Stations》regarded as standard magnitude,we calculate the magnitude deviation of Mb?MB?Ms?Ms7 and their correction coefficient in Mudanjiang seismic stationKey worksCorrect coefficient;Magnitude deviatio
选用牡丹江地震台记录的震源深度h≤80km的地震资料,以《中国地震台临时报告》(文中简写为《临报》)给出的震级为标准,对Mb、MB、Ms、Ms7分别进行了震级偏差统计计算,给出了牡丹江台数字地震仪各种震级的最佳校正系数。
补充资料:校正
校对订正:~错字ㄧ重新~炮位。
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条