1) target cut-off voltage
靶截止电压
2) target cut off voltage
靶截止电压(摄像管)
3) cut-off voltage
截止电压
1.
The absolute value of this voltage of the raising point is considered as the cut-off voltage of the material of the negative pole of the photoelectric tube, and as the result of that, th.
以此抬头点电压的绝对值作为光电管阴极材料对各种单色光的截止电压，则截止电压对于光照频率的相关因数高达０。
2.
This paper briefly introduces the basic principles to measure plancks constant by photoemission and the three methods to measure cut-off voltage.
本文简单介绍了光电效应测普朗克常数实验的基本原理及测量截止电压的三种方法。
3.
The paper introduced the method of measuring Plank’s constant by determining the cut-off voltage in photoelectric effect experiment.
介绍了光电效应实验中通过确定截止电压测量普朗克常数的方法,并分析了实验中产生误差的原因,指出减小误差的方法。
4) stopping voltage
截止电压
1.
In this paper,the errors of measuring Plank constant in photoelectric effect experiment are analyzed,and inflexion method is compared with intersection method when determining stopping voltage.
分析了光电效应实验中实际测量普朗克常数时误差产生的原因,确定截止电压时应用交点法和拐点法相比较,并应用最小二乘法进行直线拟合求出较精确的普朗克常数值。
2.
The new method suggests that the value of "stopping voltage" corresponding to different frequency is determined under the condition .
对室温下光电流的J-U曲线的分析表明 ,除T =0K情况外 ,光电子无明确的最大动能 ,也无明确的截止电压概念 。
5) negative cut-off grid voltage
负截止电压
6) voltage/current restriction
电压电流截止
1.
In this paper,the defects of conventional contro l methods for induction heating power supply is pointed out,the primary principle of PI controller is briefly described,and the control circuit based on double closed-loop is designed,also,the working principle of this circuit based on constant power output control and voltage/current restriction is analyzed.
分析了其实现恒功率输出及电压电流截止功能的工作原理。
补充资料：标准操作冲击电压波形(见冲击电压发生器)
标准操作冲击电压波形(见冲击电压发生器)
standard switching impulse voltage waveform
b .oozhun CooZuo ChongJld，onyo boxlng标准操作冲击电压波形(standard switchingimpulse voltage waveform)见冲击电压发生器。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条