1) protrusion allowance
凸出容差
2) jut
[英][dʒʌt] [美][dʒʌt]
凸出，伸出
3) protrusion
[英][prə'tru:ʒn] [美][pro'truʒən]
凸起;凸出物
4) tolerance
[英]['tɔlərəns] [美]['tɑlərəns]
容差
1.
Fault diagnosis of circuits with tolerance based on body and KNN method;
基于集团法和自组织神经网络的容差电路故障诊断(英文)
2.
A Combining Genetic Algorithm With Simplex Method in Optimum Assignment for Circuit Component Tolerance;
GA混合参数寻优在电路参数容差分配中的应用
3.
A new Fault Diagnosis Method of Subnetworks in Tolerance Analog Circuits;
容差模拟电路子网络级故障诊断的新方法
5) allowance
[英][ə'laʊəns] [美][ə'lauəns]
容差
1.
Throclgh loss function calculating the allowance ,thestandard tolerances of hole and shaft are defined.
用田口理论建立孔、轴配合的质量损失函数，给出配合的功能极限（用户容差）和用户损失的决定方法。
2.
Using Genichi·Taguchi′s approach,this paper gives all formulas that are suited for calculating the allowances of mechanical parts′ non-fit measurements.
本文以质量损失函数为计算基础，得出零件非配合尺寸的容差计算公式。
3.
After investigating and eaxmining the user s allowance, loss and factory s loss of the small diameter of inside thread and large diamtcer of outside thread respectively, the factory allowance of the small diameter of inside thread and large one of outside thread can be computed by using the loss function.
依据质量工程学的损失函数理论 ,建立紧固螺纹配合间隙的质量损失函数 ,推导出内、外螺纹中径的工厂容差的计算公式 ;最终的制造公差和精度等级按此计算值来查表选定。
6) The state of being convex.
凸出凸出的状态
补充资料：凸出
1.高出;高起。 2.超出一般地显露出来。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条