1) Parity Error
配类误差
2) parity or mark-track error
配类或标示轨误差
3) MISCLASSIFICATION PROBABILITIES
误分类误差
4) assembling error
装配误差
1.
The assembling errors for the stabilization mechanism can significantly influence the performance of sight-line stabilization.
稳定机构的装配误差是造成视轴偏差的重要误差源。
2.
The assembling error of three-axis turntable is unavoidable during assembling process,which is one of the primary system error sources.
作为造成三轴转台最终误差主要的系统误差源,装配误差在装配过程中难以避免。
5) Error distribution
误差分配
1.
On the error distribution and its analysis in the physical experimental design;
物理实验设计中的误差分配和误差分析
2.
Based on the error distribution requirement in the measurement for attached conducting wire in engineering survey the calculating procedure for the measurement of attached conducting wire is deduced from different observing angle and two useful formulas that can be directly applied to the calculation are obtained.
根据工程测量中附合导线测量的误差分配需要,依照观测角的不同,推导附合导线测量的计算过程,并推导出两个实用计算公式。
6) Registration error
配准误差
1.
An effective LUCCD method to decrease the effect of registration error;
一种有效的减弱配准误差影响的LUCCD方法
2.
When using rectangles as the target,it s difficult to measure the Modulation Transfer Function(MTF) of the space camera accurately because of the registration error between the image of the target and the pixel of the CCD at the initial sampling.
在采用矩形靶标测量航天相机系统MTF时,由于采样初始时刻靶标像与CCD像元间存在配准误差,因此给准确测量系统MTF带来很大困难。
3.
Methods After analysis of elements of the matching algorithm, the different registration algorithm performance are evaluated by the use of a comprehensive registration error based on C ++ to be realized, which can compare with the evaluation results of traditional target registration error.
方法:分析各配准要素的算法原理后,基于C++加以实现,提出使用综合配准误差来评价不同配准算法的性能,并与传统目标配准误差的评价结果作对比。
补充资料：误打误撞
1.谓事先未经周密考虑。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条