1) relay status
继电器状态
2) relay normal condition
继电器正常状态
3) relay status indicator
继电器状态指示器
5) Solid-State Relay
固态继电器
1.
The working principle of the micro-computer PLC control system is introduced which consists of SCM 8031,alternating current (AC-SSR) and direct current solid-state relay (DC-SSR).
介绍了由单片机 80 31及交、直流固态继电器组成的微机 PLC控制系统 ,对机床电、液开关量实行自动控制 ,并解决了多种控制逻辑任
2.
As to the failures existing in dynamic reactive power compensation device with solid-state relay,the theoretical and experimental analysis is made for the residual voltage occurred during the switching of capacitor.
针对固态继电器在动态无功补偿应用中的故障,就电容切除时固态继电器上出现的残压进行了理论和实验分析,探讨了实际运行中由于该残压损坏固态继电器造成补偿装置故障的原因。
3.
The principle,structure and characteristic of a solid-state relay the scope of AC-DC solid-state relay are discussed.
阐述了固态继电器的原理、结构、特点及交流直流固态继电器的适用范围 ,并针对交流固态继电器 ,提出了根据它的几个关键参数来合理选择固态继电器的方法、应用电路在设计上需要注意的一些问题以及给出了相应与计算机驳接的接口电路。
6) solid state relay(SSR)
固态继电器
1.
Based on solid state relay(SSR) s small volume,compact layout and strong EMI radiation,a layout simulation model of SSR PCB with control circuit and main loop was established by Ansofi.
基于固态继电器印刷线路板(PCB)体积小、布线紧密和电磁辐射发射较强,采用Ansofi软件建立了含有控制电路、主回路的固态继电器PCB上连线的仿真模型。
2.
The characteristic on input-output response and ambient temperature of solid state relay(SSR) is elaborated,the typical application of various SSR is introduced,which takes BESTALL SSR as the example,and the attentive matters of the SSR in use is pointed out.
阐述了固态继电器的输入-输出响应特性和环境温度特性,以百特继电器为例介绍了各种固态继电器电路的典型应用,指出了固态继电器在使用中的注意事项。
3.
By building a high frequency model of electronic elements and printed circuit board in solid state relay(SSR),extracting its parameters,an accurate simulation model of SSR was obtained.
通过建立固态继电器中电子元件和印制导线的高频模型,提取其寄生参数,得到固态继电器精确仿真模型。
补充资料：C17400铍铜制成的继电器簧片
C17400铍铜制成的继电器簧片
c1 74。C铍铜制成的继电器簧片
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条