2) retrograde condensate
反凝析
1.
The influence of retrograde condensate on productivity of condensate gas well;
反凝析对凝析气井产能的影响研究
2.
Dry gas injection huff and puff is one of the effective techniques to remove the retrograde condensate blocking of condensate gas wells.
注气吞吐是解除凝析气井单井反凝析油堵塞问题的有效方法之一。
3.
If water vapour occurs in the gas-condensate system,the pressure-temperature figure area increases,the retrograde condensate area increases and init.
水汽存在时相包络线所围面积增大,反凝析区面积增大,初始凝析压力增大;水的极性很强,会加快凝析油的挥发;在恒质膨胀与定容衰竭中含水汽凝析气体系和普通凝析气体系的反凝析液量与压力曲线会出现交点。
3) retrograde condensation
反凝析
1.
Using numerical simulation method, the retrograde condensation saturation variety and the development effect of the single well dry gas injection is studied.
应用数值模拟技术,研究地层中反凝析液饱和度的变化规律和注干气吞吐技术的开发效果。
2.
Removal of the near-wellbore plug and gas lock resulted from retrograde condensation is a key problem to be tackled during the recovery of deep-buried, low-permeable condensate gas reservoirs.
解除近井反凝析堵塞和水锁是深层低渗凝析气藏开发必须解决的难题。
3.
With more and more discoveries of deep and low-permeability gas condensate reservoirs, understanding of the retrograde condensation behavior is an important basis of making a wise development plan.
深层低渗透凝析气藏的数量越来越多,了解其反凝析特征是气藏开发正确决策的重要基础。
4) inversion solidification
反向凝固
1.
Production of H90-steel-H90 clad coil by inversion solidification;
反向凝固法生产H90-钢-H90复合带
2.
Microstructure and Properties of H90 steel Cladding Strip in Inversion Solidification;
H90/钢反向凝固复合带的组织与性能
5) inversion casting
反向凝固
1.
Influence of element diffusion on interface in compound strips during the inversion casting and high temperature rolling;
反向凝固与高温轧制过程中元素互扩散对复合界面的作用
2.
Experimental study of inversion casting of copper clad steel;
铜/钢反向凝固复合实验研究
3.
Inversely,the inversion casting process and the electromagnetic concasting process have an advantage in competition,but their processes are imperfect and needed to make further improvement.
反向凝固法和电磁连铸法具有很强优势,但工艺还不成熟,有待进一步深入研究。
6) abnormal condensate
反常凝析
1.
According to research on abnormal condensate phenomena, it is believed in this paper that the reason for these phenomena is not the same as what have been described.
通过对反常凝析现象的研究,认为造成这种现象的原因,并非书本中所认为的那样,而是一种钻入与吞噬造成分子间距离的变化,引起的这种反常凝析现象。
补充资料：反向凝固
反向凝固
inversion solidification
fanx旧ng ninggu反向凝固(inversion Solidifieation)一种薄带连续铸钢工艺。从示意图上可看出该工艺是利用一条薄带(冷轧、热轧均可)作为母带，母带经一定的处理后从反向凝固器的底部穿过，反向凝固器存放保有一定过热度和一定溶池高度的钢液，母带以一定速度不停地由下向上运动通过钢液，此时在母带表面上产生钢的凝固生长，并带动一部分钢液粘附其上共同上升，当钢带离开钢液熔池后，利用安置在反向凝固器上方的一对铸轧辊对钢带表面进行平整、轧制，铸轧辊起到拉坯和促进凝固层与母带之间焊合的作用，在铸轧辊后面安放普通的带钢轧机组生产出薄带。反向凝固最大的优点是能够生产复合材料即生产凝固层钢种与母带钢种不同的特殊要求的带钢。鬃 (姚留材)
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条