1) splash zone
飞溅区，稀相区
2) splash zone
飞溅区
1.
The corrosion behavior of hot dip Galvanized(GI),Galfan(GF) and Galvalume(GL) coated steels exposed to splash zone of Qingdao site was investigated with seawater corrosion test and microscopy morphology analyses.
6%硅(GL)镀层钢板在青岛站的飞溅区海水腐蚀行为,并利用腐蚀质量损失测试和显微结构分析,研究3种镀层钢板的海水飞溅区腐蚀行为。
2.
Corrosion results of 12 types of copper alloys exposed to marine splash zone at Qingdao Sea area of China were reported.
研究了12种铜合金在青岛海域飞溅区暴露16年的腐蚀结果及其腐蚀行为和规律。
3.
Based on the using conditions of aluminium-steel joints,we exposed such samples in splash zone,ebb and flow zones in Qingdao,Zhoushan and Xiamen areas.
按照爆炸复合材料的应用条件,将铝-铝-钢投放在青岛、舟山和厦门3个海域的潮差和飞溅区,暴露1a后研究了材料的腐蚀和力学性能。
3) Seawater splash zone
海水飞溅区
4) dilute phase
稀相区
1.
The rule of the distributor of entrainment particles in the dilute phase of turbulent fluidized bed has been studied in Φ1 200×12 000/Φ1 000×5 000 large FCC regenerator.
在一套 Φ1 2 0 0 mm× 1 2 0 0 0 mm/Φ1 0 0 0 mm× 5 0 0 0 mm的大型有机玻璃流化床中考察了 FCC催化剂在稀相区夹带粒度分布的情况 ,得出夹带颗粒与稀相高度及表观气速的分布规律 ,即随着高度的上升 ,小颗粒所占分率逐渐增多 ,大颗粒所占分率逐渐减小。
5) dilute phase zone
稀相区
1.
The regularity of longitudinal distribution of entrainment rate which varied with observed Velocity, freeboard height, internals type, size and location, was studied respectively in the case of setting internals in dilute phase zone and condense phase zone.
研究了当内部构件分别设在稀相区和浓相区时,夹带速率的轴向分布随表观气速、自由空域内的高度及内部构件的类型、尺寸、放置位置的变化规律。
6) small freeboard
低稀相区
补充资料：飞溅
向四外溅：钢花～，铁水奔流。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条