1) vacuum accessories
真空附件
2) vacuum accessary
真空设备用附件
3) vacuum absorption
真空吸附
1.
This article elaborated the "inductive jet" principle of air current and the application in draining water accumulated in the factory,explained the feasibility and practicability of using vacuum absorption as the power supply to drain water automatically in the enterprise.
从实际应用的角度出发,阐述了气流“引射”原理及其在工厂排除积水中的应用,说明了利用真空吸附为动力源在企业中进行自动排水的可行性和实用性。
2.
The redundant control theory was applied in the vacuum absorption system of wall cleaning robot,and its feasibility was analyzedt,hen a model was established.
将冗余控制理论应用于负压式壁面爬行机器人的真空吸附系统中,分析了冗余理论应用于真空吸附系统的可行性并建模,提出了提高其安全性的有效措施——双真空泵冗余系统。
4) vacuum desorption
真空脱附
1.
The paper researched on the mass and heat transfer of vacuum pressure swing adsorption (VPSA), focusing on the vacuum desorption process which is a difficult point and often simplified as the inverse process of adsorption in the previous documents.
本文针对其中的真空变压吸附进行了研究,侧重于以往研究中常简化处理的难点——真空脱附阶段。
5) vacuum suction
真空吸附
1.
According to air flow control principle,by adoption of pneumatic line drive technology and vacuum suction technology,pneumatic feeding mechanism was manufactured.
根据气压流体控制原理,采用气动直线驱动技术和真空吸附技术,研制出气动送料机。
2.
In this paper,the biodegradable seeding containers from waste cotton linters and used paper were deve loped by making fibers in the linters/paper pulp adhere to the surface of a net mold under vacuum suction.
以废棉短绒和废纸为原料 ,采用真空吸附网模成型工艺 ,直接生产出可生物降解育苗钵。
3.
A novel wall-climbing robot mechanism is presented based on planetary gear train movement and biped vacuum suction principle.
基于行星轮系运动及双足真空吸附原理,提出了一种新型爬壁机器人机构,介绍了机构的构型及结构特点,推导了运动学方程,分析了沿直线行走、平面旋转和跨越交叉壁面三种运动模式。
6) vacuum adsorption
真空吸附
1.
A new way to pick up tissue for bio-microdissection:vacuum adsorption;
适用于生物显微切割操作的真空吸附拾取组织新方法
2.
Adsorption force calculation for vacuum adsorption of target Pellet;
靶球真空吸附装置中吸取力的计算
3.
The design adopts the vacuum adsorption technique and in-wheel driving, and makes the cleaner adsorbed on the working surface and run smoothly, matches the clean machine of revolving brushes and single-chip microcomputer control system.
该设计采用真空吸附技术和轮式驱动方式,使清洁机能够在工作表面吸附并且能够平顺行走,配以旋转刷式清洗机构和单片机控制,可完成整个工作表面的清洁工作。
补充资料：特性吸附与半胶束吸附
特性吸附与半胶束吸附
specifical adsorption and hemi-micelle adsorption
texing xifu yu banJ旧oshu xifu特性吸附与半胶束吸附(speeifieal adsorp-tion and hemi一mieelle adsorption)矿物一水界面的吸附的两种形式。特性吸附是因矿物表面与溶液中某种组分(离子或分子)有特殊的亲和力而产生的吸附，也称特殊吸附。特性吸附不仅可以改变电位的数量而且还可以改变电位的符号。例如，刚玉(A12O3)在NaZSO‘或RSO;Na(烷基硫酸钠)溶液中，电动电位随溶液浓度的增大由正值逐渐减小，直至变为负值，说明刚玉对50矛一或RSO不离子有特殊的吸引力。半胶束吸附是水溶液中的表面活性剂在矿物表面产生的吸附，当吸附量达到一定值以后，由于烃基的缔合作用，表面活性剂的离子或分子在矿物表面上形成紧密的吸附层，这类似于溶液中形成的胶束结构，但所形成的“胶束”与溶液中形成的胶束不同，只有二维空间，故称这类吸附为半胶束吸附。矿物表面对胺类捕收剂的吸附，当胺的浓度较大时，常可以产生半胶束吸附。 (龚焕高)
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条