1) off-axial mode
偏轴模
2) simulant eccentric bush
模拟偏心轴瓦
1.
How to use a simulant eccentric bush to resolve an eccentric bore of bearing support;
如何使用模拟偏心轴瓦解决瓦座孔偏心问题
3) Decentration
[di:sen'treiʃən]
轴偏
1.
Decentration Surveying Instrument of Infrared Thermal Imaging Optical Lens;
红外热像光学镜组轴偏测量仪
4) axis deviation
轴线偏移
1.
2 Sewage Treatment Works, the key factors of group sinking well axis deviation and its relationship with well wall soil body asymmetrical disturbed are analyzed.
通过对上海竹园第二污水处理厂工程实例,分析了影响群体沉井轴线偏移的主要因素以及井壁四周土体不对称扰动与群体沉井轴线偏移的关系,提出了对群体沉井轴线偏移的事先控制和过程控制的措施。
5) axial deviation
轴线偏差
1.
The relation between supporting load of rotary kiln and axial deviation is worked out with the help of regression analysis,which will be the basis for mastering the operation of rotary kiln.
通过将筒体轴线偏差转化为回转窑支承载荷分配中的给定位移,灵活地计入了轴线偏差对支承载荷分配的影响。
6) Eccentric axle
偏心轴
1.
In this paper,the formula of combustion gas pressure which act to eccentric axle of rotary engine has been given in theory.
从理论上推导了转子发动机偏心轴瞬时气动力计算公式,应用有限元技术,计算了某转子发动机偏心轴的强度,从而为偏心轴设计和定型提供依据。
补充资料：在AutoCAD中偏心圆锥与偏心圆台实体的画法
现在要画一个偏心圆锥,底面在WCS的XY平面上,圆心(0,0,0),半径100,顶点(300,0,400)在ZX平面上.
1)连接PA,PB. A(-100,0,0) B(100,0,0)
图1
在当前坐标下:
2)延长PA到C,使PA=CA;延长PB到D,使PB=DB;
3)连接CD;
4)以CD为直径画圆;
5)用XLINE命令中的二等分选项作角CPD的角平分线PO,交CD于O;
6)过O作CD的垂线,交圆于E,F;
图2
7)用三点UCS命令,取三点为:O,P,C;
8)过点O作PO的垂线GO,交PC于G;
图3
9)再次用三点UCS命令,取三点为O,F,G;
10)现在就可以画椭圆锥了!
cone-e-c-捕捉O点-捕捉F点-捕捉G点-a-捕捉P点;
图4
11)回到WCS,剖切椭圆锥
SL-选择椭圆锥-回车-XY-回车-捕捉P点.
12)删除辅助线条.
图5
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条