说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 红外调制器
1)  infra-red modulator
红外调制器
2)  solid state infrared modulator
固态红外调制器
3)  infrared modulation
红外调制
1.
The new type velocity sensor takes infrared modulation circuit to lower the effects of surrounding light on velocity measurement, and its the velocity data acquisition system is equipped with industrial pulse counting block.
新型流速传感器采用红外调制电路以克服环境光对流速测量的影响 ,流速数据采集系统采用工业化脉冲计数模块 。
4)  tunable mid infrared laser
中红外调制激光器
5)  external modulator
外调制器
1.
Effect of chirp in external modulator on 10 Gbit/s dispersion compensation system;
外调制器啁啾对10 Gbit/s色散补偿系统的影响
2.
The key points to design high speed burst mode external modulator are presented,the effects of extinction ratio and chirp on optical transmitter are discussed,then the matching technology is discussed in detail.
阐述了高速突发模式外调制器电路的设计要点,着重讨论了消光比、啁啾对光发射机的影响,对匹配问题进行了详细讨论,设计了性能良好的前向匹配电路及电吸收调制器驱动电路,其工作速率为12 Gb/s,运用这些技术设计的光发射机消光比大于23。
6)  infrared suppressor
红外抑制器
1.
Experimental research on infrared suppressor integrating the exhaust system with the tail part of a helicopter;
排气系统与尾机身一体化红外抑制器实验分析
2.
Based on Fluent soft,Some numerical simulations were carried out for the fluid fields which established from the schemes of the installation of the lobed nozzle infrared suppressor installed on helicopter.
基于Fluent软件,针对波瓣喷管红外抑制器的不同装机方案,进行了其内部和动力舱全流场的数值模拟。
3.
Aiming at the infrared suppressor for a type of turboshaft engine which exhausts in front,a new idea of suppressor structure combining lobed nozzle with film cooling mixing duct is brought forward,with the purpose of decreasing infrared radiation of the mixing duct wall.
针对某型后向进气、前向排气的涡轴发动机用红外抑制器,提出了波瓣喷管和气膜冷却混合管组合的红外抑制概念,旨在进一步降低混合管壁面红外辐射强度。
补充资料:红外调制技术
      在进行红外天文观测中,为了抑制来自天空和望远镜背景的干扰,也为了使天体的辐射变为交流信号以便处理,在红外望远镜中广泛采用调制技术。一般是调幅,即对天体的红外辐射(在投到探测器之前)以低频进行方波调制,探测器交替得到"源信号加背景"和"背景",后面的电子线路放大的是二者之差,这样就把微弱的"源信号"从强的背景起伏中检测出来。用在红外望远镜中的调制通常有三种方式:①摆动望远镜的主镜(这是最理想的);②摆动望远镜的副镜;③安置焦平面调制器(斩波器),即在焦平面前一点,设置旋转或平移的小反光镜系统。这三种方式都是为了快速地交替观测天空两个相邻位置,获得调制信号差。摆动大口径望远镜的主镜很不容易,实际上最常用的是后两种方式,这可以用不同的光学机械装置和电路来加以实现。对调制器的要求是:调制函数应尽可能接近于方波,调制交替的两个最终状态应当很稳定,调制频率应等于所用红外探测器的最佳调制频率,以获得最大的输出信噪比。红外调制技术也广泛应用于军事工业和尖端科学的红外系统中,它们除采用调幅外,还采用调频、调相和脉冲编码等方式。
  

说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条