1) forced mode locking
强制锁模
2) forced locking
强制闭锁
3) forced locking device
强制闭锁装置
4) forced demoulding
强制脱模
1.
If the lateral uplift has enough distortion space, it could be forced demoulding.
给侧向凸起留出足够的变形空间,可强制脱模。
2.
And the mechanisms of forced demoulding, two_time ejection and delayed ejection by a sliding core used in the injection mould were introduced.
分析了沐浴露瓶盖的工艺特点 ,介绍了瓶盖注射模的结构及工作过程 ,并介绍了注射模设计中采用的强制脱模、二次顶出、滑动型芯延时顶出机构等。
3.
The structure characteristics and working process of the mechanisms for 3_time ejection, forced demoulding, delayed kicking out the sliding core adopted in the design of the injection mould for the lid of the lotion bottle were introduced.
介绍了洗面奶瓶盖注射模设计中所采用的3次顶出、强制脱模、滑动型芯延时顶出等机构的结构特点及工作过
5) forced demolding
强制脱模
1.
The combined application of two-stage ejection and forced demolding in injection mold
注塑模中二次顶出、强制脱模的联合应用
6) PLL control / modeling
锁相环控制/建模
补充资料：鼻前孔狭窄、闭锁
鼻前孔狭窄、闭锁
stricture and atresia of anterior naris
多为烧伤感染等瘢痕粘连和挛缩的结果。双侧鼻孔狭窄可引起呼吸不畅。闭锁时则需完全用口呼吸，以致常感口干舌燥等。鼻前孔狭窄的治疗可按“Z”成形术原则或用鼻唇沟皮瓣修复，闭锁者则须将鼻孔的瘢痕组织切除，使鼻尖、鼻翼、鼻小柱等充分复位后，用内嵌植皮法修复鼻孔内创面。术后至少半年内，应持续用硅胶管或塑料管支撑鼻孔，防止皮片收缩，每次取出清洗后须即刻放回。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条