说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 光晶胶
1)  clean plastic (cean polyester)
光晶胶
2)  colloidal photonic crystals
胶体光子晶体
1.
High-quality PS colloidal photonic crystals were fabricated quickly from aqueous colloidal solutions by a vertical deposition method at certain temperature and liquid surface dropping velocities and its photonic band gap was at 626 nm.
通过控制溶剂蒸发温度和液体表面下降的速度,用垂直沉积法较快速地制备出了在较大范围呈现很好有序性的密排结构聚苯乙烯胶体光子晶体,其在626 nm波长处存在光子带隙。
2.
High-quality silica colloidal photonic crystals were fabricated quickly from aqueous colloidal solutions by a vertical deposition method at certain temperature and liquid surface dropping velocities.
通过控制溶剂蒸发温度和液体表面下降的速度,用垂直沉积法快速地制备出完整的二氧化硅胶体光子晶体。
3.
Based on the transmission characteration of optical fiber and the methods of fabrication colloidal photonic crystals,electric field-controlled method is used to fabricate colloidal photonic crystals with the photonic band-gap(PBG) in communications wavelength.
基于对光纤传输特性和胶体光子晶体制备方法的研究,提出了用外加电场控制的方法制备光子带隙位于通讯波段的FCC结构的胶体光子晶体,并用光纤系统测试胶体光子晶体的带隙特性。
3)  Colloid crystal
胶晶
1.
Three-Dimentionally Ordered macroporous titanium-silica mixed oxides were successfully synthesized by using polystyren sphere colloid crystal as the template and the sol of tetraethyl silicate and tetrabutoxy-titane as the filling fluid.
以聚苯乙烯微球离心后形成的三维规则排列的胶晶作模板,用钛酸丁酯和正硅酸乙酯分别和水、乙醇等配制成的混合溶胶填充微球之间的间隙,然后原位形成凝胶,最后通过焙烧(<5℃/min;300℃,5h;570℃,5~10h,空气流速1L/min)除去微球得到三维规则排列的大孔钛硅混合氧化物。
2.
Three dimensionally ordered macroporous silica was successfully synthesized using latex sphere colloid crystal as template and sol of tetraethyl orthosilicate, water, ethanol and hydrochloric acid as filling fluid.
以聚苯乙烯微球离心后形成的三维规则排列的胶晶作模板 ,以正硅酸乙酯、水、乙醇和盐酸等配制的溶胶填充微球间的间隙 ,然后原位形成凝胶 ,最后通过焙烧除去微球得到三维规则排列大孔二氧化硅材料 。
3.
Periodic macroporous titanium dioxide were successfully synthesized using PS colloid crystal as templates which were made by centrifuging latex sphere, filling in the voids with sol of terabutoxy_titane, and then transforming into gel in situ and removing latex sphere by calcinations.
以聚苯乙烯微球 (LatexSphere)离心后形成的三维规则排列的胶晶 (colloidcrystal)作模板 ,用钛酸丁酯、水、乙醇等配制的溶胶填充微球之间的间隙 ,然后原位形成凝胶 ,最后通过焙烧除去微球得到三维规则排列大孔TiO2 材料 (3DOM)。
4)  colloidal crystal
胶晶
1.
Polystyrene colloidal crystals were assembled by natural sedimentation,centrifugation and vertical deposition methods.
采用自然沉降法、离心法和垂直沉积法组装了聚苯乙烯胶晶。
2.
Polystyrene colloidal crystal films(PCCF) were assembled by vertical deposition method.
采用垂直沉积法组装了三维聚苯乙烯胶晶膜,并用其为模板制备了三维有序大孔(3DOM)SiO2膜。
5)  cryogel
晶胶
1.
A novel supermacroporous cryogel with sulfo binding groups used in cation-exchange monolith was prepared by in-situ grafting of 3-allyloxy-2-hydroxy-1-propanesulfonic acid sodium salt (AHPSA) onto the pore surfaces of polyacrylamide-based cryogel.
采用原位接枝法,将3-烯丙氧基-2-羟基-1-丙磺酸钠(AHPSA)接枝到聚丙烯酰胺基晶胶基质孔隙内表面,制备得到了阳离子交换型连续床用的带磺酸基超大孔晶胶介质。
6)  colloidal photonic crystal films
胶体光子晶体薄膜
补充资料:光晶
1.光辉;明亮。 2.指精义。
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条