1) additional bending stress
附加弯曲应力
2) additional bending stress coefficient Ke
附加弯曲应力系数Ke
3) additional bending
附加弯曲
4) bending stress
弯曲应力
1.
Finite element analysis on the bending stress for roller spur bevel gear based on ANSYS;
基于ANSYS的滚齿直齿圆锥齿轮弯曲应力有限元分析
2.
Analysis of tooth root bending stress for spiral bevel gears;
弧齿锥齿轮齿根弯曲应力分析
3.
Calculation of bending stress of steel-concrete composite beam considering slippage effect;
考虑滑移效应的钢—混凝土组合梁弯曲应力计算
5) bend stress
弯曲应力
1.
The article anaylses the skew arch roofing s bend stress under symmetry and unsymmetrical loads,calculates the skew arch roofing critical load under the symmetry and unsymmetrical loads,the result indicates the skew arch roofing s resistance,and stability are sufficient for its use.
分析了在对称和非对称载荷作用下斜拱型屋面弯曲应力,计算了在对称载荷和非对称载荷作用下斜拱型屋面临界载荷。
2.
This paper demonstrate the way how to measure and control D max -D min of the pressure cylinder for its safe working,which is started with the circular additional bend stress which is caused by the non circularity of the pressure cylinder,then it points out a new method of controlling strength of the pressure cylinder.
从压力容器不圆度引起周向附加弯曲应力出发 ,推导出检测和控制不圆度值的方法 ,使其达到其安全工作的目的 ,为工业生产及检测部门提供依
3.
This paper points out a proplem in《Mechanial Design of Forestry Engirieer-ing》Writted by Fu Wenfan that formula in calculating the bend stress of the hook.
本文指出了傅文范等著《森林工程机械设计》(绞盘机)中涉及到的关于吊钩钩身弯曲应力公式存在的问题,并根据有关理论,提出比较符合实际的计算吊钩钩身弯曲应力的公式。
6) bending stresses
弯曲应力
1.
Software Development on Finite Element Analysis for Bending Stresses of Transmission Gears;
变速器齿轮弯曲应力分析有限元软件的开发
2.
It has been shown that bending stresses that inadvertently occur due to misalignment between the applied force and the specimen axes during the application of tensile and compressive forces can affect the test results.
在材料拉伸和压缩试验期间,由于加力轴线与试样轴线不同轴产生弯曲应力,影响试验结果。
补充资料:Reactive Green KE-4B
分子式:
CAS号:
性质: 黑色粉末。在浓硫无酸中呈深绿色。在浓硝酸中呈紫色。水溶液为深蓝绿色,加1mol/L氢氧化钠转蓝色,继续加保险粉并温热,成无色,再加过硼酸钠仍无色。对氨基苯磺酸与三聚氯氰第一次缩合;对硝基苯胺邻磺酸重氮化,分别在H酸的羟基邻位和氨基邻位偶合,然后还原,再与第一次缩合物进行第二次缩合,经盐析,过滤,干燥而得。用于棉、黏胶纤维的染色和织物印花。
CAS号:
性质: 黑色粉末。在浓硫无酸中呈深绿色。在浓硝酸中呈紫色。水溶液为深蓝绿色,加1mol/L氢氧化钠转蓝色,继续加保险粉并温热,成无色,再加过硼酸钠仍无色。对氨基苯磺酸与三聚氯氰第一次缩合;对硝基苯胺邻磺酸重氮化,分别在H酸的羟基邻位和氨基邻位偶合,然后还原,再与第一次缩合物进行第二次缩合,经盐析,过滤,干燥而得。用于棉、黏胶纤维的染色和织物印花。
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条