2) crepe degree
起绉程度
1.
The experimental results show that these feature values can reflect the crepe degree of a crepe from different sides;it has closely linear co.
提出一种客观评价绉织物起绉程度的方法,该方法将基于平行光轴投影光栅系统的傅里叶变换轮廓测量方法应用于绉织物三维表面重建,结合数字加权滤波检测绉织物表面三维轮廓数据,并从获得的绉织物三维轮廓数据中提取粗糙度、分形维数、表面面积、平均偏移量4个特征值。
3) starting process
起动过程
1.
Investigation on the starting process of the direct impulse combustion wind tunnel
直连式脉冲燃烧风洞起动过程研究
2.
The result showed that the conveyor has big design parameter,appropriate starting velocity,little dynamic belt tension change and steady starting process.
通过对大倾角上运带式输送机的起动过程进行分析建模,给出了其边界条件和求解方法。
3.
During the research of 11kW rare earth permanent magnet brushless DC motor starting process,the control strategy by slope voltage was used to reduce the higher current.
在对11 kW稀土永磁无刷直流电动机起动过程研究中,针对起动电流过大,采用斜坡电压的方法进行控制。
4) pilling process
起球过程
5) process of starting and braking
起闭过程
6) initiating process
起爆过程
1.
Then the initiating process of the Nonel tube is determined.
文中通过微光照度法测定导爆管起爆段相对浓度变化,从而确定导爆管的起爆过程。
补充资料：起程
1.出发上路。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条