2) two-way wedge
双向斜楔
1.
The float plate block and slide block are controlled by the two-way wedge and located by the ringer.
该模具的凹模由固定部分和活动部分组成,浮动凹模镶块和滑块部分由双向斜楔控制、套环定位,保证了横向和纵向压料的精度,满足了零件质量要求。
3) two-stage inclined pipe
双级斜管
1.
The new de-oiling settler of two-stage inclined pipe settling wall was divided into two stages.
新型的双级斜管沉淀墙除油沉淀器分为两级,前一级为异向流斜管沉淀和粗粒化除油,后一级为斜管隔油。
4) space double inclined hole
双斜孔
1.
Taking the machining diesel engine cylinder nozzle hole as example, the course of working fixture body used in machining space double inclined hole is analyzed and the design formulas of dimensional tolerance are deduced.
以 75系列柴油机汽缸盖喷油嘴孔的加工为例 ,分析了空间双斜孔加工用夹具体的加工过程 ,推导了其尺寸公差的设计公
5) double inclined wedges
双斜楔
1.
The structure of the bending die with double inclined wedges for forming the frame part and the design of the main parts of the die were introduced.
分析了固定架零件的工艺特点 ,确定了成形工艺方案 ,并介绍了成形该零件的双斜楔弯曲模的结构及模具主要零件的设计。
6) double oblique positions
双斜位
1.
Analysis of technique on double oblique positions of lumbar vertebrae;
腰椎双斜位摄片技术分析
补充资料：斜楔式侧孔冲模
工件套在件6上用件9上的台阶定位，而件9用件18防转并且起到圆周方向定位的作用，当上模下行时，件5先将工件压牢，上模继续下行时，由斜楔4推动件11和装在件11上的件8完成冲孔工作。当上模上升时件11在件4的作用下退回，按下件16，工件由与件16相连的件9顶出．
工件图
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条