2) inspection of mounting of bearing seating
轴承座安装检验
3) bearing saddle bore
轴承座孔
1.
Taking the correction of the gear shaft and bearing saddle bore of a reducer as the example, this paper probes into the problem of the correction of the gear shaft and bearing saddle bore often encountered in the inspection of e lectromechanic equipment, and according to the practical experiences, makes emph atically discussion on the brush plating repair technique.
以某减速机齿轮轴与轴承座孔的修复为例,对机电设备检修工作中经常遇到的齿轮轴和轴承座孔修复问题进行了探讨,并根据实践经验对刷镀修复工艺要点进行了重点论述。
4) main bearing wall
主轴承座
1.
To validate the FEM calculations of the cylinder block of a six-cylinder in-line diesel engine,the dynamic strain-stress and temperatures of the main bearing walls and caps were measured on engine testbed with strain-gauge and resistance thermometer.
为评估某直列6缸柴油机缸体有限元强度分析结果,采用应变电测法实测了该发动机缸体上可能的危险部位主轴承座、主轴承盖动态应力以及这些部位的温度。
2.
Since the boost pressure of a diesel engine is increased,the FEM analysis of the main bearing wall to evaluate the structural strength was conducted.
对某直列6缸柴油机提高增压压力后主轴承座的结构强度进行了有限元分析。
5) main bearing hole
主轴承孔
1.
The system is based on the air-electric sensor technology,which can automatically measure cylinder hole and main bearing hole of the cylinder block,make grouping and marking and meet high precision measure requirements.
工业计算机控制的发动机缸体测量系统是由气动测量芯轴和差压式测量回路等组成,系统采用气电转换技术,在线自动测量发动机缸孔和主轴承孔并分组打号,满足了生产现场高精度测量的要求。
2.
It′s always one of the difficulties to machine main bearing holes on bedplate for large bore diesel engines.
大缸径柴油机机座主轴承孔的加工技术一直是柴油机制造的一大难点 ,现提出了采取的一系列工艺技术措施 ,解决了柴油机生产中的这一关键技术问题 ,提高了大缸径柴油机机座主轴承孔的制造水
6) instrument for checking waviness of tracks
检验轴承滚道波纹度仪器
补充资料：第二孔(继发孔)型缺损
第二孔(继发孔)型缺损
ostium secondary defect
是心房间隔在形成上发生障碍，一般缺损较大，多在卵圆孔附近称第二孔(继发孔)型缺损。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条