1) pneumotachometer
气流速度计
2) air velocity
气流速度
1.
The scrap absorbing system was introduced in details,such as the constituent,determination of air velocity,pipeline arrangement,layout of scrap absorbing unit and the control and interlock between principal machines for edge cutting.
介绍了碎边吸收系统的组成、气流速度的确定、管道布置、碎边吸收风机的选择布置、与切边主机之间的控制连锁。
2.
This paper analyzes the influence of indoor air velocity and the effects of setting of exterior shade,direction of glass curtain wall,glass types and glasses filled different gas on energy consumption in glass curtain buildings.
本文分析了室内气流速度、设置外遮阳、幕墙朝向、玻璃类型和玻璃夹层的填充气体等因素对玻璃幕墙建筑能耗的影响。
3.
CFD software Fluent was applied to simulate the air velocity of fire arresters, and the relation was analyzed between structure parameters, temperature and air velocity.
应用Fluent软件模拟空气在防爆格栅中气流速度,定性分析了平板阻火单元不同结构和温度与气流速度的关系。
3) flow velocity
气流速度
1.
That was accomplished through a series of experiments at different flow velocity,with the same smoldering cottons put directly at the entrance of the FE/DE and in box,respectively.
实验结果表明,在烟颗粒生成过程不受气流影响的情况下,两种感烟探测器的响应灵敏度均随气流速度增大而下降。
2.
To study the phenomena occurring in plasma aerodynamic actuation and the mechanism of plasma flow control,the induced flow velocity of the plasma aerodynamic actuator is experimentally investigated under a variety of parameter conditions.
为了探索等离子体流动控制的内在机理,在不同的参数条件下,对等离子体气动激励的诱导气流速度进行了实验研究。
5) flow rate
气流速度
1.
Effect of flow rate on dry powder inhalers deposition in vitro;
气流速度对粉雾剂在呼吸道沉降的影响
6) airflow velocity
气流速度
1.
The results showed that the wheat equilibrium moisture content under static air current is higher than that under some airflow velocity,and the time when the wheat reaches moisture absorption balance under some airflow velocity is longer than that under static air curr.
结果表明,气流相对静止的条件下,小麦所达到的平衡水分要高于一定气流速度下的平衡水分,且在一定气流速度下达到吸湿平衡的时间比静态气流下明显延长;通过小麦的空气流速越大,水分增加幅度越大,平衡水分值越高,达到平衡的时间越短;根据Page方程获得了一定条件下小麦含水率和实验时间的回归方程,二者具有很高的相关性。
补充资料：DWP喷射气流干燥机
工作原理：
DWP型属喷射气流带式干燥类型，热风以狭缝流或孔束流向下或上下同时喷向输送带上的物料，由于喷射气带高达15m/s以上，故对流传热的传热膜极薄，传热系数大，干燥速度快。该设备用于不透气类物料时，上面喷射气流仍返回上面，下面喷出的气体仍返出下面，再参与循环。对透气性物料如涂膜布干燥等，也适用于片状物料及一些特殊物料的干燥。如果采用双向气流喷射，板材之类物料干燥后变形小。喷射气流干燥使用热源可以是蒸气、电、热风炉及燃油烟道气等。
应用范围：
喷射气流带式干燥专用设备，比如纸浆干燥一般为S型或M形结构的多层式，大型纸浆模则为单层式。前者输送为吊蓝型，后者为为网带输送型。并且热风温度、循环气体量、湿度、气流速度及气流束形式不为其它物料所通用，实际差别很大。
对用户的咨询，我厂工程师会迅速作出详细的合理的设计方案，愿与用户一道，促使我们的设备性能更好，效益更好。
技术参数：
名称\参数\序号 | DWP-Ⅰ | DWP-Ⅱ | DWP-Ⅲ | |
带宽m | 1.6 | |||
干燥段长m | 8 | |||
铺料厚mm | 10-80 | |||
使用温度oC | 50-120 | |||
蒸汽压力Mpa | 0.2-0.6 | |||
换热面积m2 | 330 | 296 | 259 | |
干燥时间h | 0.2-1.2 | |||
风机数量 | 3 | 2 | 2 | |
传动机功率Kw | 0.75 | |||
风机功率 KW | 7.5*3*2 | 7.5 3 | 7.5 3 | |
外形尺寸 | 10*2.1*3.6 | |||
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条