1) respiratory time
吸入时间
2) Prolonged Treatment
延时吸入
3) absorbent time
吸水时间
1.
Fluff-specific volume,absorbent time and absorbability are the key physical qualities of fluff pulp.
介绍用实验室自制的检测仪器测定进口绒毛浆的干蓬松度、吸水时间和吸水量,所得数据与国外提供的绒毛浆检测指标相对照,发现两者十分接近,检测结果具有很好的一致性。
4) siphonage time
虹吸时间
5) adsorption time
吸附时间
1.
The effects of the size of steel slag,slag dosage,the pH of solutions and adsorption time on the adsorption of aniline with steel slag were investigated.
考察了钢渣粒度、用量、溶液pH值和吸附时间等因素对水中苯胺吸附效果的影响,结果表明,在适宜的条件下,钢渣对苯胺的吸附去除率可达75%以上。
2.
The effects of sludge concentration, adsorption time, temperature and quality of inlet water on the adsorbability of the sludge were investigated with the aerobic sludge and anaerobic sludge for the treatment of municipal wastewater as the subjects.
以处理城市污水的好氧污泥和厌氧污泥为对象,考察污泥浓度、吸附时间、温度和进水水质对污泥吸附性能的影响。
3.
The results show that the property of adsorption depends on adsorption time、pH and temperature.
实验结果表明:活性炭的吸附性能取决于吸附时间、废水pH值和废水温度。
6) Suction time
抽吸时间
1.
Influences of suction time,membrane flux and mixed liquid characters on membrane transfer resistance,which was used as an indicator of membrane fouling in the present study,were investigated.
以膜传质阻力的变化来表征膜污染的状况,在一体式膜-生物反应器处理高浓度有机废水的条件下,分别考察了抽吸时间、膜通量和混合液性质对膜传质阻力的影响,并分析了SS浓度和上清液溶解性有机物浓度(COD)与膜传质阻力之间的关系。
2.
Through a group of test by means of orthogonal table,influence of suction time,suction suspended time and aeration rate on membrane filtration was investigated.
正交试验结果表明，缩短抽吸时间或延长暂停时间和增加曝气量均有利于减缓膜污染，但过短的抽吸时间、过长的暂停时间和过大曝气量不能进一步地减轻膜污染，因此应在保证一定产水量的前提下确定适宜的抽、停时间和曝气量。
3.
The orthogonal experiments were designed,involving three factors: aeration intensity,suction time and suction suspended time,in order to research into membrane fouling of jet loop membrane bioreactor.
选取抽吸时间、停抽时间和曝气强度3个因素设计正交实验,考察喷射环流膜生物反应器膜污染情况。
补充资料：泵额定吸入压力
分子式：
CAS号：
性质： 为泵额定工况(排出压力、流量、功率等)工作条件的入口压力。
CAS号：
性质： 为泵额定工况(排出压力、流量、功率等)工作条件的入口压力。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条