2) bobbin appearance
筒子外观
3) cylinder subjected to external pressure
外压圆筒
1.
Based on the principles used in ASME VIII-1 and other codes, the comparison of design methods for the cylinder subjected to external pressure in AD code and ASME VIII-1 was carried out.
本文据ASMEⅧ -1及其它有关规范的制订原理 ,对AD规范和ASMEⅧ -1的外压圆筒设计方法进行比较 ,并指出GB150-1998对厚、薄壁界限的修改有所不
2.
On the basis of the calculation method for the cylinder subjected to external pressure and the relevant content in ASME VIII-1, the revision of the calculation for the cylinder subjected to external pressure was discussed in this paper.
本文以外压圆筒的稳定性计算原理和ＡＳＭＥⅧ－１为基础，对ＧＢ１５０－１９９８的修订提出商榷。
4) outer sleeve
外套筒
1.
In this paper,the reason for the outer sleeve crack in vehicle is analysed and discussed The reswlt obtained shows that the outer sleeve erack is caused by both a certain amout of impurty elements in outer layer of the sleeve and periodic stres
就汽车某外套筒裂纹失效进行了测试与分析研究，结果表明：裂纹产生的原因是外套筒表层存在大量的杂质元素并承受周期性的大应力。
5) Outpressure cylinder
外压筒体
6) external flow guiding cylinder
外导流筒
1.
This paper deals with the stress and strength of the nozzle zone of the external flow guiding cylinder of the shell and heat exchanger by numerical analysis of FEM and experimental stress analysis, giving the theoretical and experimental distribution laws of stresses with the aid respectively of three dimension finite element in 8 to 12 changing sopots and of the electrical measuremet.
本文应用有限元数值分析和实验应力分析两种方法对管壳式换热器外导流筒接管区的应力和强度问题进行了研究。
补充资料：筒子纱染色
分子式：
CAS号：
性质：又称纬管纱染色(cop dyeing)。将纱线卷绕在带有孔眼(或以金属丝做成的)管蕊上形成锥形筒子纱，分别固定在一特备的笼架上，再装入专用密闭染色机内，用泵将染液由内向外或逆向在纱线空隙间进行多次循环流动，以获得均匀的染色效果。
CAS号：
性质：又称纬管纱染色(cop dyeing)。将纱线卷绕在带有孔眼(或以金属丝做成的)管蕊上形成锥形筒子纱，分别固定在一特备的笼架上，再装入专用密闭染色机内，用泵将染液由内向外或逆向在纱线空隙间进行多次循环流动，以获得均匀的染色效果。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条