1) three limb tube
三臂管，三通管
2) three-limb tube
三臂管
3) three-way pipe
三通管
1.
Improvement on the forming process and design of die for three-way pipe;
三通管成形工艺改进与模具设计
2.
Research on distribution of fluid flow in three-way pipe;
流体通过三通管路的流量分配研究
3.
Taking a three-way pipe as an example, the whole manufacturing process of rapid tooling was introduced.
以三通管为例,具体讲述了快速模具制造及铸造的整个工艺过程。
4) tri-branch tube
三通管
1.
Analysis of axial force and internal pressure bulging process for tri-branch tube with the elastic and plastic medium;
弹、塑性传力介质下三通管轴压胀形工艺分析
2.
Simulation and validation of axial force and internal pressure bulging process for copper tri-branch tube;
紫铜三通管轴压胀形数值模拟及验证
3.
To explore the influence of maximal internal pressure on forming tri-branch tube,the procedure of forming tri-branch tube is simulated by FEM software MSC.
以内高压成形三通管过程中最大内压的影响为研究目标,采用有限元分析软件MSC。
5) Three-way Straight Pipe
三通直管
6) T-tube
三通管
1.
Numerical Simulation Study of Two-dimensional Turbulence in T-tube;
三通管二维湍流数值模拟
2.
Aiming at the defects of conventional processing method and parts technical requirements,multiple expansion method was used for the hydro-forming of T-tube.
针对三通管传统加工方法的缺点和零件工艺性要求,拟采用多次胀形的方法对三通管进行液压成型。
补充资料：衡阳钢管厂φ108三辊轧管机轧制毛管
衡阳钢管厂φ108三辊轧管机轧制毛管
衡阳钢管厂事108三辊轧管机轧制毛管
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条