1) frictional resistance
摩擦抗力;摩擦阻力
2) Frictional Resistance
摩擦阻力
1.
Influence of the frictional resistance for deadline anchor axis on weight indicator accuracy;
死绳固定器轴上摩擦阻力对指重表精度的影响
2.
Influences of frictional resistance on flow distributions of the dividing and combining manifolds;
摩擦阻力对分流和汇流联箱流量特性影响
3.
A method for lateral buckling analysis of tubing with frictional resistance in deviated wells was presented.
提出了在斜直井中钻柱正弦屈曲分析时对摩擦阻力的处理方法,给出了考虑摩擦阻力时的屈曲平衡方程,建立了相应的微分求积法列式,用微分求积法时平衡方程直接求解。
3) Friction resistance
摩擦阻力
1.
An experimental investigation on the flow and heat transfer of the narrow-gap annular tube vapor generators.Ⅱ.Friction Resistance.;
窄缝环形管内流动与传热实验研究 Ⅱ.摩擦阻力特性
2.
Based on the analysis of macrostructure and microstructure of the sample after ECAE, the influence of friction resistance between the die wall and the sample on the deformation of the sample billet was discussed.
通过对挤压后纯铝试样的宏观变形及微观形貌分析,探讨了ECAE过程中模具内壁与试样之间的摩擦阻力对试样变形的影响,得到了滞变区比例与挤压位移之间的关系。
3.
In daily mine ventilation work,we treat as airway friction resistance factor a constant.
在矿井通风业务实际计算中认为 :对于某特定巷道的摩擦阻力系数视为一定值 ,不考虑其随风流流向改变而改变。
4) friction force
摩擦阻力
1.
In this paper,the effect of friction force on metal forming parameters has been summarized based on some last research reports.
论文基于近期已发表的文献 ,综述了摩擦阻力对金属成形参数的影响。
2.
The paper introduces the method and principle of testing friction force between mould plates and strand on the slab caster.
介绍了板坯连铸机结晶器铜板与铸坯摩擦阻力的测试原理和方法，分析了铜板与铸坯之间的摩擦状态与摩擦阻
3.
What s more,the produced friction force and the added moment,which act on the transmission shaft,influence equipment performance and increase equipment load.
通过对齿轮联轴器工作时的运动和受力分析得知,当补偿轴向位移、径向位移和角偏差时,在接触齿面之间存在滑动摩擦,滑动速度较大,使齿轮联轴器容易磨损破坏;并且在传动轴上产生摩擦阻力和附加弯矩,影响设备性能,增大设备负荷。
5) friction drag
摩擦阻力
1.
Analysis of PTFE Composition Seal Ring and Calculation of Its Friction Drag;
聚四氟乙烯组合密封圈及其摩擦阻力的计算
2.
Effect of blowing and suction on friction drag of wall turbulent boundary layer
吹吸扰动对壁湍流边界层摩擦阻力的影响
3.
Analysis of friction drag in scramjet isolator
隔离段内超声速流动摩擦阻力分析
6) frictional pressure drop
摩擦阻力
1.
The frictional pressure drop increases with the mixture ve.
对垂直下降管中CO2泡沫压裂液的管流阻力特性进行了实验研究,二氧化碳泡沫压裂液的摩擦阻力随着流速的增大而增大,随着温度和压力的增大而减小;并通过实验研究得出了泡沫压裂液在垂直下降管中流动时的摩擦阻力系数的计算关联式,其在本文实验工况下的平均计算误差为14。
2.
With oil,gas,water as working fluids,the experiment studies of frictional pressure drop characteristics of oil gas,gas water two phase flow in vertical helically coiled tubes were carried out.
分别以油气、气水为工质，对立式螺旋管内气液两相流的摩擦阻力特性进行实验研究。
3.
Single-phase frictional pressure drop in microchannels were experimentally investigated, using nitrogen and water.
336 mm)中采用两种直接取压方式-缝隙取压和小孔取压,对单相摩擦阻力特性进行了实验研究,并通过改变缝隙宽度,研究缝隙宽度对压降测量偏差的影响。
补充资料：摩擦阻力
分子式：
分子量：
CAS号：
性质：见流体阻力。
分子量：
CAS号：
性质：见流体阻力。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条