1) preliminary pile
试探桩
2) pile detection
探桩
3) the stake Test
桩基试桩
4) test pile
试桩
1.
This paper describes the classification of the pile,the importance of test pile.
介绍了桩的分类,试桩的重要性。
2.
Self-balance test pile technique is applied to check the bearing capacity of big diameter cast-in-place pile,providing experience for similar problems in engineering.
通过实践应用自平衡试桩法新技术,对大直径钻孔灌注桩承载能力进行检验,为解决施工中出现的类似问题提供经验。
3.
The analysis of steep local drop in the Q-S curve from static load test on test pile reveals that the true soil condition at test pile location should be representative, and the differences in the true soil might cause deviations in pile load bearing capability.
通过对试桩静载荷试验出现的Q-S曲线局部陡降情况的分析,说明选择试桩位置的土层条件应具备代表性,土层差异可能导致桩承载力取值的偏差。
5) testing pile
试桩
1.
Based on stratum analysis and estimation on bearing capacity of single pile,a new design on testing pile is put forward in this paper.
通过单桩承载力估算及分析,将原试桩方案进行了修改,经过对试桩进行自平衡检测,证实改良方案满足设计荷载要求,从而为新的工程桩参数设计提供了理论依据,降低了工程成本,缩短了施工工期。
2.
It may be good instruction for the design of testing pile and anchor pile in the static loading test.
本文从结构设计的角度,对目前工程中常见的单桩竖向抗压静载试验进行力学分析,指出设计中容易忽视的地方,并提出了相关建议,对静载试桩中试桩和锚桩的设计有一定的指导意义。
3.
After testing pile and determining the load bearing capacity of single pile,the single piling method is adopted for construction.
采用沉管灌注桩法处理软土地基 ,经试桩并确定单桩承载力后 ,采用单打法进行施工。
6) pile test
试桩
1.
The construction parameters were obtained after many times of pile test.
通过现场多次试桩结果确定高压旋喷桩的施工参数,实施过程中严格按有关规定进行控制,最终取得高压旋喷桩水下施工的成功,为以后的同类施工积累了宝贵的经验。
补充资料：暗桩
1.植立于水中而不露出水面的木桩。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条