1) crossflow fan
横流通风机
2) Cross-flow fan
横流式通风机
3) Cross-flow fan
横流风机
1.
By means of test aiming at the three characteristic parameters which influence the performance of cross-flow fan ,derives some results,and carries out statistical analysis on them ,and finally obtains the indensity of impact on.
针对影响横流风机性能的三个特征参数进行了实验 ,并对实验结果进行统计分析 ,得出了各参数影响程度的强弱关系。
2.
In this paper,a fundamental working condition and an equation of cross-flow fan are put forward.
提出了横流风机正常工作的基本条件,导出了横流风机的基本方程,从理论上证明了这种风机具有较高动压的特性。
3.
In order to study the suction characteristic and the work conditions for fans in series,based on the tests of the single cross-flow fan and the single centrifugal fan,experiment study on the suction characteristic of cross-flow fan and centrifugal fan in series is carried out.
为研究异类风机串联后的吸气特性及适合风机串联的工况条件,笔者在横流风机和离心风机单机吸气性能试验的基础上,进行了横流风机与离心风机串联吸气性能试验。
4) cross flow fan
横流风机
1.
Probed into relation of power and efficiency of two cross flow fans series and single fan, and found speed of fan is fixed in second sequence have more effect to power and efficiency of tw.
在大量试验的基础上,分析了两横流风机串联时总排气性能与单机排气性能的关系。
2.
On the basis of the previous work, we analyzed the relationships between flow field and cleaning performance and made clear the influences of the changing of the cross flow fan’s location parameters on cleaning performance.
阐述了双风机圆筒筛清选机构的清选原理,测量了该机构横流风机在3种工况下的流场;分析了流场的特点及横流风机位置参数变化对流场的影响规律,指出了流场的理想状态及改善清选性能的途径。
5) cross-flow fan
横流式风机
6) axial flow fan
轴流通风机
1.
Study on pressure head characteristic of axial flow fan combined water jet dust-extraction fan;
轴流通风机与水射流除尘风机联合工作压头特性研究
2.
The article introduces the working mode and principle of axial flow fans used in coal mines,and explains in detail the influence of the S-curves of the air-tunnel on air loss and design of the S-curves.
文章介绍了煤矿用轴流通风机的工作方式和原理,并详细论述了通风道"S"弯处对风量损失的影响,以及通风道"S"弯处合理的设计方法。
3.
Carries out numerical simulation of the whole flow field,it is from the inlet of the collector to the outlet of the diffuser,in counter-rotating axial flow fan with the realizable turbulent model and the pressure boundary conditions.
采用Realizablek-ε湍流模型和压力边界条件对对旋式轴流通风机从集流器到扩散器出口的内部流场进行了数值模拟。
补充资料:横流通风机
见通风机。
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条