1) closed-loop control
死循环控制
2) closed control system
死循环控制系统
3) circulating control
循环控制
1.
Analysis on circulating control characteristic of open to air check valve for high pressure feed-water system;
高压供水系统空排止回循环控制阀组特性分析
4) cycle control
循环控制
1.
Application of Single Transducer Cycle Control on Water Supply System at Constant Pressure;
单变频器循环控制在水厂恒压供水中的应用
2.
For the spark-ignition LPG-methanol engine whose electronic-controlled injection was done in the inlet,the cycle injection quality ratio of LPG-methanol,the injection timing of LPG lagging behind methanol,and the influence of ambient temperature on cold start performance were researched on the base of cycle control method.
针对进气道电控喷射点燃式LPG—甲醇发动机,基于循环控制方法研究了LPG与甲醇循环喷射量质量比、LPG迟后甲醇喷射时刻和环境温度对LPG—甲醇发动机冷起动性能的影响。
3.
In the application of PLC Technology, the frequent faults in the program design of PLC time sequence and cycle control are that sequence act and cycle control controlled by TIM can′t be implemented.
PLC技术应用中 ,时间顺序循环控制程序设计经常出现的错误是 :不能实现TIM控制的顺序动作和循环控制。
5) cycle-by-cycle control
循环控制
1.
The transient firing behavior of a spark-ignition engine fueled with gasoline,liquid petroleum gas(LPG) and methanol respectively during cold start was investigated experimentally by means of cycle-by-cycle control strategy on a 125 mL-single-cylinder four-stroke electronically controlled fuel injection engine.
基于循环控制策略,在一台125 mL单缸四行程电控喷射点燃式发动机上,分别燃用汽油、LPG和甲醇3种燃料进行了冷起动瞬态工况着火特性的试验研究。
2.
The effects of the injection timing and the ignition timing of methanol on the firing behavior and HC emission of the engine were studied by means of the cycle-by-cycle control technique.
基于循环控制研究了点火正时和喷射正时对甲醇发动机冷起动的着火特性和HC排放的影响。
补充资料：裂解循环控制
分子式：
CAS号：
性质：在噬菌体DNA转录途径中的控制，即按裂解途径还是按溶源途径进行。以λ噬菌体为例，如果所生成的蛋白质是cI阻遏蛋白，则进入溶源途径；如果生成的是CrO蛋白则进入裂解途径。
CAS号：
性质：在噬菌体DNA转录途径中的控制，即按裂解途径还是按溶源途径进行。以λ噬菌体为例，如果所生成的蛋白质是cI阻遏蛋白，则进入溶源途径；如果生成的是CrO蛋白则进入裂解途径。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条