1) taper pin
锥销，斜销
2) tapered pin
锥形销，斜销
3) taper pin method
锥[斜]销方法
4) conical pin
锥销
1.
Nonlinear analysis with contact elements is adopted in ANSYS program in this paper to calculate the stress status in the fork type blade roots, fork type disc grooves and the conical pins while they are assembled as an integral structure and acted by the steam flow and the centrifugal forces.
为了获得汽轮机叉形叶根和锥销的受力情况 ,本文首先采用ANSYS有限元程序的接触单元非线性方法计算叶片、轮盘及锥销装配在一起 ,在叶片受到汽流力与叶片、轮盘及锥销在离心力的作用下的应力状态。
5) oblique pin
斜销
1.
Design and Skill on Die Casting Die with Oblique Pin Drawing Core;
斜销抽芯式压铸模设计过程与技巧
2.
Conclusion is made that process selection of flat pin,oblique pin and soldered pin should be in conformity with the situation of production and punching specification with proper tools and proper specifications.
通过对早期有销织针工艺与现代无销织针工艺的比较,提出了无销针工艺具有的不可比拟的优势,重点分析了冲销工艺的特性、注意事项及冲销的几种不同形式,指出平销工艺、斜销工艺、焊销工艺的选择应根据各自的生产特点以及冲销规格,并选择合适的冲头、制定合理的工艺参数。
6) Angle pin
斜销
1.
Die Casting Die with Angle Pin-rack-gear Secondary Core-pulling Mechanism;
斜销-齿条-齿轮二次抽芯压铸模
2.
The thesis presents a practical die structure with dog-leg cam and angle pin for secondary combined angle core pulling of die casting draw hooks.
本文给出了拉钩铸件弯销-斜销二级联合斜向抽芯压铸模实用结构,论述了模具分型面的确定、结构特点和工作原理。
3.
The thesis presents a practical die structure with angle pin and gear shaft and rack for secondary combined inclined down loosing core of die casting hopper bodies.
本文给出了浮子室体铸件斜销-齿轴-齿条二级联合斜下抽芯压铸模实用结构,论述了模具结构特点和工作过程。
补充资料：活销销
1.方言。指开关。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条