1) steering knuckle turning angle
转向节转角
2) the panel zone
转角节点
1.
This paper mainly investigates the load capacity of the side panel zone in steel gabled frames by static test of four connections by comparing the panel zone with and without the inclined stiffener.
当工程中门式刚架转角节点处,梁、柱处于正弯矩作用即转角节点域外翼缘受压时,建议架设斜加劲肋以防止结构失稳。
3) Joint rotation angle
关节转角
5) steering angle
转向角
1.
Research of 4WS 0f automobile with proportion of steering angle;
汽车转向角成比例四轮转向的探讨
2.
Injection mould of linker with steering angle stated in this paper needs to position and adjust the consistency of inserted pin with 90°steering angle.
本文所述的转向连接器注射模,需要对具有90°转向角的插针一致性进行定位和校正。
3.
A new method to control dynamically the braking force distribution on turning a vehicle is proposed on the principle of forward-feed control of steering angle, with the intention of meeting the demand of braking stability on turning a vehicle under any road condition.
提出了一种对制动力进行动态分配控制的新方法·在车辆的转弯制动过程中,采用转向角前馈控制原则,对左、右车轮的制动力进行动态分配控制,使之在各种路况下均能满足制动稳定性的要求·并且通过建立的两自由度三轮车辆模型,进行了计算机模拟·模拟结果显示采用转向角前馈控制的制动力动态分配的方法,大大降低了在制动起作用时间内实际横摆率与理想横摆率之间的差值,从而验证了该方法对提高车辆转弯制动过程中的操纵性和稳定性是有效的
6) axle steering angle
轴转向角
1.
First,the design axle steering angle was obtained from the simulation,then ADAMS/Insight was used to reduce the axle steering angle to zero,to optimize variable rear suspension links hardpoints,and to improve vehicle operational stability.
先求出影响整车操纵稳定性的后桥轴转向角的初始值,然后利用ADAMS软件Insight模块,以轴转向角趋近于0为目标,以后悬架杆件控制点的坐标为变量进行优化设计,得到控制点的坐标值,使整车操纵稳定性得到改善。
补充资料：地球自转角速度
rotational angular velocity of the earth
地球自转角速度:
地球本体绕通过其质心的旋转轴自西向东旋转的角速度。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条