1) ordinary welding deposition rate
普通焊熔敷速度
2) deposition rate
熔敷速度
1.
The effects of proportion of mixed gas, welding current, arc voltage and gas flow rate of mixed gas shielded arc welding of flux cored wire on the deposition rate, deposition coefficient and deposition efficiency were studied with shielding gas of Ar+CO2.
以Ar+CO2作为保护气体,研究了药芯焊丝混合气体保护焊的混合气体配比、焊接电流、电弧电压和气体流量对熔敷速度、熔敷系数和熔敷效率的影响。
2.
It is presented preliminary assessment of new plasma technology with both high deposition rate and low rate of dilution ,which was developed under the calculation and analysis of compressive properties of plasma are, arc flame characteristics and kinematics behavior of poweder in the arc.
人们衡量堆焊方法一般总是从两个方面进行 ,一是熔敷速度 ,二是稀释率。
3.
The Influence of powder feeding mode on the deposition rate was emphatically analyzed here.
介绍了目前等离子弧粉末堆焊常用的几种送粉形式 ,较详细地分析了其利弊 ,着重分析了送粉方式对粉末熔敷效率的影响因素 ,并通过大量分析及实验验证 ,给出了同时获得高熔敷速度低稀释率的最佳送粉形
3) re melt deposit welding
熔敷焊
1.
A new welding process-re melt deposit welding is studied in the article.
研究了一种新的焊接工艺方法——熔敷焊接方法 ,采用该方法在 3 0 mm口径弹体上焊接纯铜弹带取得成功 。
4) build-up electrode
熔敷焊条
5) deposition rate
沉淀速度，熔敷速度
6) rate of deposition
沉积速率;熔敷速度
补充资料：阴敷
1.谓遍布于阴湿之地。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条