1) intensity
[英][ɪn'tensəti] [美][ɪn'tɛnsətɪ]
强[密]度，应力
2) stress density
应力密度
1.
On this basis,the solution methods for the two kinds of initial equilibrium membrane surfaces with equal stress density or equal stress are proposed.
在此基础上,提出了气承式薄膜结构等应力密度及等应力两类初始平衡曲面的求解方法。
3) stress intensity
应力强度
1.
Fuzzy reliability design of random stress intensity of pressure vessels;
压力容器随机应力强度的模糊可靠性设计
2.
Detail information of stress analysis process and evaluation principle for vertical slender vessel producing polyurethane were given,illustration of some key problems in the process of applying load was made and model for finite element analysis was set up,results calculated by ANSYS under different working conditions were given and the stress intensity was checked.
从压力容器分析设计的角度阐述了聚氨酯合成塔应力分析的过程及评定原则,分析了有限元模型的构建及各种载荷施加中存在的问题,利用ANSYS软件计算了各工况下的应力强度并进行了强度校核,为塔器的分析设计提供了可供工程应用的参考设计方法。
3.
The research of the relationship between the accumulation of the acoustic emission signal formed in the plastic zone of the crack tip and stress intensity factor is conducted.
对裂纹尖端形成塑性区时产生声发射信号的累计数与应力强度因子的关系进行研究。
4) Stress Strength
应力强度
1.
Evaluation on the Stress Strength at the Junction Area between the Cylinder of an Internal Pressure Vessel and Its Big Nozzle
内压容器筒体与大接管相贯区的应力强度评定
5) intension-stress
强度应力
1.
That is when the difference of the intension-stress and stabilization-stress is bigger,the component is wrecked for lose- stabilization.
即:构件的强度应力和稳定应力相差较大,使构件在强度还很富裕时就因失稳而破坏,对钢结构设计具有指导作用。
6) Stress-intensity
应力-强度
补充资料：轧辊残余应力(见轧辊应力)
轧辊残余应力(见轧辊应力)
residual stresses in roll
zhagun eanyu yingli轧辊残余应力(residual stresses in roll)见礼辐应力。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条