1) end play dimension
轴向间隙尺寸
2) gap dimension
间隙尺寸
3) axial dimension
轴向尺寸
1.
Starting from the valve structure relative to valve axial dimension, the structure, theory, adjusting method, operating method and characteristic for the special comparer which can be used for inspecting multiple axial parameters of engine valve in time are introduced in detail on the basis of the precondition of the unification between measuring benchmark and designing benchmark.
从与气门轴向尺寸有关的气门结构特点入手,介绍了有关在测量基准与设计基准统一的前提下可同时进行气门多个轴向尺寸测量的专用检具的结构原理、调节方法、使用方法等。
4) axial size
轴向尺寸
1.
Process main, journal mouth, shoulder platform and crankshaft whose axial size needs more precision using the lathe of numerical control—CAK6150P.
利用CAK6150P数控车床加工主轴颈当口、肩台、轴向尺寸精度较高的曲轴。
5) steering pivot clearance dimension
转向回转间隙尺寸
6) axial clearance
轴向间隙
1.
Analysis the producing ways of axial clearance of bent axises on X195 diesel;
保证X195柴油机曲轴总成轴向间隙几种生产方式的讨论
2.
The method of eliminating axial clearance,logical fixing configuration and effective guard of ballscrew nut pair are all introduced in this paper.
介绍滚珠丝杆螺母副轴向间隙的消除方法、合理的安装结构和有效的防护装置。
3.
It was found that these faults were attributed to(1) the excess axial clearance of the rolls at the bearing seat,and(2) the excess bouncing resulting from the unbalanced force applied to the rubber mat of the rolls.
经分析,原因是轧辊非传动端轴承座装配的轴向间隙过大,且螺纹公差偏大,所以造成轧辊窜动严重以及原用胶垫受力不均衡,弹跳过大。
补充资料：工程图标准尺寸及坐标尺寸
标准标注类型，是我们常用的标注类型。而坐标标注是便于数控加工采用的另一中标注形式。PRO/E可以将两种标注方式进行转换。
· 3.2 标准标注到坐标标注的转换
注意： 转化为坐标标注的尺寸必须是线性标注的，下列尺寸不能转化为坐标标注：
- 被显示成线性尺寸的直径
- 中心线尺寸
- 选择MODIFY DRAW > Dim Params > Dim Type > Ordinate Dim > Create Base.
- 选择作为参考基准线的尺寸
- 选择基准的引出线，该点为0点
- 选择 MOD DIM TYPE > Lin to Ord .
- 选择线性尺寸：注意：必须选择具有相同基准的尺寸
========>>>>
1. 选择 DIM PARAMS > Diam Dim Type .
2.点击Ord to Lin 
3.选择尺寸即可
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条