2) shaft bearing end play adjustment
轴承轴向间隙调整
3) Bearing Clearance Adjustment
轴承间隙调整
4) Bush's gap adjustment
轴瓦间隙调整
5) adjustable end play
可调轴向[端]间隙
6) axial clearance
轴向间隙
1.
Analysis the producing ways of axial clearance of bent axises on X195 diesel;
保证X195柴油机曲轴总成轴向间隙几种生产方式的讨论
2.
The method of eliminating axial clearance,logical fixing configuration and effective guard of ballscrew nut pair are all introduced in this paper.
介绍滚珠丝杆螺母副轴向间隙的消除方法、合理的安装结构和有效的防护装置。
3.
It was found that these faults were attributed to(1) the excess axial clearance of the rolls at the bearing seat,and(2) the excess bouncing resulting from the unbalanced force applied to the rubber mat of the rolls.
经分析,原因是轧辊非传动端轴承座装配的轴向间隙过大,且螺纹公差偏大,所以造成轧辊窜动严重以及原用胶垫受力不均衡,弹跳过大。
补充资料：弯曲模的间隙调整装置
图1为弯曲模的间隙调整装置。在下模上开有长方形孔，其一端带有6°斜度。调整块安装在长方形孔内，相应的面也有6°斜度。调正杆头部是一个偏心圆柱体。调正杆旋转，偏心圆柱体带动调整块上、下滑动，由于有6°斜度，造成间隙变化，调整后用螺母锁紧调正杆。
图1 弯曲模的间接调整装置
1-下模 2-调整块 3-调整杆
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条